Caronlab Hard Wax Bean Braziliant Film Hard Wax Beads CL-2WHBFM8

Expected delivery is approximately 3 weeks from the date of order. Delivery times may vary slightly depending on your location. Description Braziliant Film Wax is the ultimate power in your pot allowing you to fly through Waxing services with lightning speed. This hybrid, stripless Wax is easy to apply and gentle on the skin like a Hard Wax with the power and grip of a Strip Wax. Boasting a flexible, pliable consistency upon application Braziliant can be applied cellophane-thin in large strips without fear of cracking and breaking. Save time and money by removing all hairs with one application. Characteristics Deep blue with a semitransparent consistency and Mandarin and Lavender scent Rosin Free Vegan Friendly Benefits Removes fine vellus hairs Low working temperature is gentle on the skin Can be applied cellophane-thin in large strips without fear of cracking and breaking Non-brittle, flexible application removes stubborn hairs with ease Where To Use Face (brows, chin, lip, beard) Intimate (Brazilian, Hollywood, bikini line, underarms) Total Body (arms, legs, back, torso) How To Use Usage Instructions – Film Wax Area to be Waxed must be clean, dry and free from any oils and creams. Caronlab Australia recommends the use of Prep – Pre Wax Skin Cleanser as it has been designed to work together for best results with Caronlab Australia Waxes. Always test Wax on the inside of your wrist before use. Do not apply on warts, moles and broken or irritated skin. You may begin by dipping Spatula into Wax, which should be the consistency of thick gel. Apply Wax with the hair growth, leaving one edge thicker to create a lip. Film Wax should be applied in a cellophane or paper-thin sheet. Hold skin taut and remove Wax by pulling in the opposite direction of hair growth. For the perfect finish and to remove any Wax residue on the skin, we recommend you use After – After Waxing Oil and Soothe Mango & Witch Hazel After Wax Soothing Lotion or Aloe – Aloe Vera Hydrating Gel to complete your treatment. To clean equipment use Solvent – Wax Remover Citrus Clean. Important Store in a cool, dry place. Warning This is a professional product for Salon use only. Patch test before use. If skin irritation occurs, cease use. Exceeding the recommended instructions may cause burns and/or injury. Heating Instructions – Beads Place Wax Beads into the Caronlab Australia Professional Wax Heater Insert, no higher than ¾ full. Heat on the highest setting for 20 minutes. DO NOT stir during this time. When Wax is completely melted, turn down to 60°C (140°F) or between dial 3-4 on a Caronlab Australia Professional Wax Heater. Dip Spatula into the Wax which should be the consistency of thick honey, if it’s dripping it is too hot. DO NOT block the edges of the Professional Wax Heater Insert when topping up Beads. NO MORE than a scoop at a time. Always work from a ¾ full Wax Heater.