AT200 — Vehicle Awning Tent

Create a shaded, bug-screened camp space beside your vehicle in minutes—no roof rack or permanent installation required. 54 sq ft of covered space Four-sided mesh with front and rear zip doors Standard Package includes two side panels and one front/rear panel 18 lb · packs into one bag and fits in your trunk Ground sheet, light bar and extra pole kits sold separately. Dimensions & specifications Model AT200 portable vehicle awning tent Capacity 2–4 people Typical setup Around 5 minutes Unfolded size 6.6 × 8.2 × 7.2 ft Covered space Approximately 54 sq ft Canopy pole settings 5.3 ft or 5.9 ft Packed size 19.7 × 7.1 × 5.5 in Package size 21.7 × 7.9 × 5.9 in Standard Package weight 18 lb Fabric / coating 210D Oxford fabric / titanium blackout coating Frame / reinforcement Foldable aluminum alloy poles / Dyneema (UHMWPE) reinforcement Sun / rain protection UPF 50+ / PU3000+ mm waterproof fabric rating Suction mounts 4.5 in diameter; up to 800 N listed vertical holding force Standard vehicle height Above 5.2 ft; suitable clean, smooth mounting surface required Warranty 2-year warranty Check mounts and anchors during use. The suction holding force is not a wind rating. Pack down in severe weather.Standard Package Awning tent with integrated bug mesh × 1 Locking knobs × 2 Suction mounts × 2 Guy lines × 2 Carabiners × 2 Foldable aluminum alloy support poles × 2 Foldable aluminum alloy canopy poles × 2 Front/rear tent extension, 6.6 × 7.2 ft × 1 Side tent extension, 8.2 × 7.2 ft × 2 Ground stakes × 14 Accessory storage bag × 1 Main carrying bag × 1 Ground sheet, light bar, additional poles and extra panels are sold separately. Read the illustrated AT200 setup guide.Vehicle compatibility Standard mounting is designed for vehicles with a roof height above 5.2 ft. 5.2–6.2 ft roof height: Roof mounting is recommended. Above 6.2 ft roof height: Side mounting is recommended. For low-roof cars or limited mounting space, contact CAMPERIG with your vehicle model, roof height and mounting-surface photos to confirm fit or discuss optional mounting components.