ESP32 & BH1750 Light Sensor Prototyping Kit

Develop a connected light-sensing project with the ESP32 & BH1750 Light Sensor Prototyping Kit. The pre-soldered BH1750 provides digital ambient-light readings over I2C, while the 38-pin ESP32 board supplies the controller for your own logging or automation firmware. Its USB-C connection, CP2102 USB-to-serial interface and 4MB flash support ESP32 development. A matching 38-pin GPIO expansion breakout, 830-point breadboard and 20cm jumper wire set provide access for prototyping. Wire the sensor for 3.3V operation and configure the software yourself; the kit arrives as separate components.Bundle value: Purchased separately, the included component variants total $33.20. This kit is $26.99, saving $6.21. 1 × pre-soldered 38-pin ESP32 board, 4MB flash, CP2102 and USB-C 1 × 38-pin ESP32 GPIO expansion breakout board 1 × pre-soldered BH1750 digital light sensor 1 × 830-point solderless breadboard 1 × 120-piece, 20cm Dupont jumper wire set Wiring, programming and a computer are required. Use 3.3V sensor connections with the ESP32. A USB-C data cable, power source, enclosure and project firmware are not included. The parts arrive as separate components for you to assemble and configure.Read the kit setup guide for assembly planning, required extras and component references.