Model Y Juniper Rear Bumper Lip Side Splitter ABS Sport Style Rear Bumper Corner Extensions

【Compatibility】Compatible with Model Y Juniper 2025.03+ (Standard, Premium, and Performance) 【Durable ABS Construction】Made from ABS plastic, the EVBASE rear bumper side splitters combine a lightweight build with strength and toughness for everyday use. The material offers resistance to minor impacts while providing a firm structure that holds its shape. This makes it a practical choice for exterior trim mounted along the lower bumper. 【Added Lower Bumper Coverage】The splitters extend along the lower corners of the rear bumper, adding a layer of coverage in an area exposed to road debris and light scuffs. They may help limit direct contact with the covered surfaces during minor scrapes. Their protection is limited to the mounting area and does not replace careful parking or reversing. 【Straightforward Installation】Clean the mounting surfaces thoroughly, then position both pieces and check their alignment before securing them to the bumper. Make sure the left and right sides sit evenly before tightening the mounting screws. Drilling is required if suitable mounting holes are not already present, so confirm the mounting positions before making any holes. 【Raised Side Profile】Each splitter features an extended lower edge and a raised outer section, giving the rear bumper corners a more defined shape. The angular profile adds a sporty appearance that is visible from both the side and rear. It brings more visual structure to the lower bumper without requiring a full rear bumper replacement. 【Two-Piece Rear Styling Upgrade】Separate left and right pieces add matching extensions to both rear bumper corners while leaving the center section in place. This layout lets you update the outer edges of the bumper without installing a full-width rear lip. Together, the two pieces create a balanced appearance across the rear of your Model Y Juniper. 【Black Finish】The black finish works with the Model Y Juniper’s existing lower bumper trim for a coordinated appearance. On lighter body colors, it creates a clear contrast that makes the splitter shape easier to see. The simple color also keeps the focus on the shape of the extensions without adding bright accents to the rear bumper. Carry the Side Profile Around the Rear The side extensions continue the lower body line just behind the rear wheels. This creates a more connected look between the side of the car and the rear bumper when viewed from an angle. Keep the Factory Bumper Shape Visible The splitters sit beneath the existing bumper corners rather than covering them. The original bumper contours remain visible above the extensions, keeping the factory shape recognizable. Start with a Small Exterior Change The rear corner pieces work as a standalone styling upgrade, so you can install them without adding a front lip or side skirts at the same time. They offer a simple starting point if you prefer to update your exterior in stages. FAQ Q1: Do I have to drill into my bumper?+ A1: Drilling is required if your bumper does not already have suitable mounting holes. Test-fit both pieces and check their alignment before marking or drilling the mounting positions. Q2: Will these protect my bumper if I back into something?+ A2: They may help with light scuffs on the areas they cover, but they are styling accessories, not collision protection. They will not prevent bumper damage from a parking impact. Q3: Will these fit my older Model Y, or are they only for the Juniper?+ A3: These splitters are for the Model Y Juniper. They are not intended for the earlier Model Y. Check the fitment information before ordering, especially if your rear bumper has been modified.