Roof-Side LED Light Bar for INEOS Grenadier Station Wagon

Output 8,590 lm Beam Throw 530 m Sealing IP69K Boost Power 100 W Off-road trail navigation and remote camp setups often demand auxiliary lighting directed along the vehicle perimeter, yet front-mounted light bars leave the roof sides and campsite flanks in deep shadows. This 20-inch single-row LED light bar mounts directly to the factory roof side bars of the INEOS Grenadier Station Wagon, providing 8,590 effective lumens of perimeter illumination without requiring drilling or permanent body alterations. WHY THIS UPGRADE MATTERS Spot Illumination Range: Powered by 12 Luminus SST-20 LEDs, the spot optical reflector produces 286,000 candela of peak intensity and projects usable light (1 lux) out to 530 meters. Dual-Function Lighting Modes: Features dual operating modes, functioning as an 8,590-lumen high-output driving beam as well as an integrated low-draw position light. Direct Roof-Bar Clamp Mount: Vehicle-specific clamp brackets and rubber protective pads secure directly around factory round roof side rails using stainless steel hardware. High-Pressure Weather Sealing: Certified to IP67 and IP69K standards, withstanding dust ingress, water submersion, and direct high-pressure spray cleaning. Specifications Dimensions 575.8 mm x 59 mm x 53.7 mm (20-inch single-row) Materials Extruded aluminum housing with polycarbonate lens Mounting Type Factory roof-bar clamp mount (no drilling) Light Engine 12 x Luminus SST-20 LEDs (Driving) + 24 x 3030 LEDs (Position) Beam & Range 6.8° Spot beam (530 m @ 1 lux, 8,590 effective lm) Weather Rating IP67 & IP69K waterproof and pressure-wash sealed Compatibility INEOS Grenadier Station Wagon with factory roof bars (2023-2026+) Installation & Compatibility Notes This light bar attaches to the factory round roof side bars located above the rear side windows on INEOS Grenadier Station Wagon models. Position the protective rubber liners between the clamp brackets and the factory bar to prevent surface scratches. Fasten the stainless steel hardware and set the desired beam tilt angle using the serrated bracket teeth. Wire the 3-lead pigtail (Black: Ground, Red: Main Positive, Yellow: Position Light) to an auxiliary switch circuit or relay box. Confirm Station Wagon or Quartermaster fitment before ordering if your vehicle configuration is not listed on this page. Install Difficulty: 2/5 Estimated Install Time: 30-45 minutes What is Included 1 x 20-Inch Single-Row LED Light Bars 2 x Roof Bar Round Tube Clamp Base Brackets 2 x Angle-Adjustable Serrated Mounting Brackets 2 x Square-Cutout Protective Rubber Isolator Pads Complete Stainless Steel Mounting Hardware Kit (2 x Carriage Bolts, 2 x Side Bolts, 2 x Hex Nuts, 4 x Flat Washers, 4 x Spring Lock Washers) 3-Wire Connection Pigtail Cable (pre-installed, 0.5 m) Product FAQ Q: Does this light bar require drilling into the Grenadier roof or body? Mounting clamps fasten around the existing round roof side bars using supplied clamp hardware and protective rubber liners. No drilling, cutting, or body modification is required. Q: Can this light bar withstand high-pressure vehicle washing? The light bar carries IP67 and IP69K ingress ratings, which verify protection against sustained water immersion and high-pressure spray cleaning. Q: How is the light bar wired into the vehicle electrical system? The assembly includes a 3-lead wiring pigtail with negative ground, main driving light positive, and position light positive leads. Connections route to the factory auxiliary roof switch bank or an aftermarket relay harness.