Shopcorp 63 Amp 4 Pole Normally Open IEC 400V Contactor - 24VAC Coil for HVAC, AC, Motor Load, and Lighting Systems

4 Pole 63A AC Contactor with 24VAC Coil The Shopcorp 4 pole AC contactor is designed for compatible HVAC, lighting, heating, refrigeration, and electrical control applications requiring a 24VAC coil. Its four normally open main contacts allow simultaneous switching across multiple circuits in residential, commercial, and industrial control systems. Normally Open 4 Pole Switching This normally open contactor uses four main poles with terminal pairs 1-2, 3-4, 5-6, and 7-8. When the 24VAC control coil is energized through terminals A1 and A2, the contactor closes the main contacts to control the connected load. Its 4-pole configuration makes it suitable for applications where multiple conductors need to be switched together from a single control signal. 63A AC-7a and 25A AC-7b Ratings The contactor is rated for: AC-7a: 63A AC-7b: 25A Rated operational voltage (Ue): 400VAC Rated insulation voltage (Ui): 500V The appropriate rating depends on the type of electrical load and the requirements of the application. Built for HVAC and Electrical Control Applications This 63 amp contactor can be used in compatible control systems for: HVAC equipment Air conditioners Compressors Fans Heating systems Lighting circuits Resistive loads Refrigeration equipment Control panels Distribution panels Always select the contactor according to the actual load type, operating voltage, current requirements, and applicable electrical standards. 24VAC Coil Control The contactor operates with a 24VAC, 50/60Hz coil using A1 and A2 control terminals. This low-voltage coil configuration is commonly used in compatible HVAC and electrical control systems. DIN Rail or Panel Mount Installation The compact design supports DIN rail mounting for organized installation inside electrical panels and control cabinets. Its approximate dimensions are 54 × 66 × 85 mm / 2.1 × 2.6 × 3.3 in, helping simplify installation planning where panel space is limited. IEC/EN Compliant Design Designed in accordance with IEC 61095 / EN 61095 requirements for compatible electromechanical contactor applications. The unit is also CE marked.