Meguiar's Detailer Professional DA Microfiber Correction Compound D300 (3.7l)

Meguiar's D300 DA Microfiber Correction Compound (3.7L) | Automize Microfiber Correction. No Swirls. No Sling. No Compromise. Meguiar's D300 DA Microfiber Correction Compound is a professional-grade super-micro abrasive compound engineered specifically for use with microfiber cutting discs on a DA polisher — removing swirls, holograms, scratches, and light to moderate defects with a guaranteed swirl-free finish. D300 was built around a specific insight: microfiber cutting discs behave differently from foam pads and need a compound formulated to match them. Meguiar's super-micro abrasive technology cuts fast on a microfiber disc while finishing down to a high gloss — no holograms, no sling, minimal dust. The 3.7L professional size delivers a significantly lower cost per car for studios and high-volume detailers who run D300 as their primary correction compound. Super-Micro Abrasive Technology Meguiar's proprietary abrasive system cuts through light to moderate defects — swirls, holograms, scratches, acid rain etching — and finishes down to a high gloss in the same pass on a microfiber cutting disc. No Swirls — Guaranteed Meguiar's own guarantee on D300. The super-micro abrasives are engineered to correct without introducing new defects — the result is a clean, high-gloss finish directly off the DA, not hidden swirls under polish oils. No Sling, Low Dust Formulated specifically for DA use — no product sling during operation and minimal dusting, which means less prep masking, less cleanup, and faster turnaround between panels in a professional environment. Professional 3.7L Size The gallon format delivers a lower cost per car — a meaningful difference for studios and detailers running D300 across multiple vehicles daily. Rich, concentrated formula means less product per panel than thinner compounds. 🛠️ How to Use 1 Prime the Pad Shake well. Spread a small amount of D300 across the full face of a Meguiar's DA Microfiber Cutting Disc to prime it before the working application. Apply 2–4 drops for each working section after priming. 2 Polish Work in the shade on a cool surface. Set your DA polisher to around speed 4–5 (approximately 4800 OPM). Work a 2ft x 2ft section at a time with light pressure — maximum speed is not required and will not improve results. 3 Wipe & Inspect Remove excess product with a clean microfiber towel. Inspect under proper lighting before moving on. For added protection, follow with Meguiar's D301 DA Microfiber Finishing Wax on a finishing disc. Quick Reference Product Type Professional DA microfiber correction compound Abrasive Technology Super-micro abrasives (Meguiar's proprietary) Machine Dual-action (DA) polisher only — not designed for rotary Required Pad Meguiar's DA Microfiber Cutting Disc (DMC3/5/6 or DMX5/6) Speed Setting Speed 4–5 / approx. 4800 OPM Defect Range Light to moderate — swirls, holograms, scratches, acid rain Volume 3.7L (1 US Gallon) — professional size D300 is engineered for use with Meguiar's DA Microfiber Cutting Discs — results with standard foam pads will differ. This is a DA-specific compound and is not designed for rotary polisher use. Always work on a cool, clean surface in the shade. Refer to Meguiar's current product data sheet for the most up-to-date guidance. Professional correction. Gallon size. Swirl-free guaranteed. Order now for quick delivery all over Pakistan.