ULTRA H2O Foam Cannon

A High Quality Foam Cannon The Ultra H2O Foam Cannon is a foam cannon built to hold its settings. Most cannons use smooth-turning knobs that drift under vibration, so you spend the first minute of every wash re-dialing foam thickness you already set last time. This one runs a precision detent system: foam-to-water ratio, spray pattern, and 360 degree rotation all click into position and stay there. Set it once and it repeats, wash after wash. That consistency is the whole point, and it is what separates a tool built for detailers from a cannon built to look good on a shelf. Shop the rest of our foamers and sprayers. The details back it up. A triple-filter system produces thick, even foam with real coverage, and two orifices, 1.1 and 1.25, come in the box so you can match output to your machine. The weighted pickup tube keeps drawing consistently as the bottle empties instead of sucking air at an angle, and a quarter-turn lid makes refills fast. The wide-mouth HDPE bottle has clear measurement markings with rubberized grip points, stainless steel internals handle the long haul, and the whole unit is rebuildable. Load it with a quality foaming soap and run it off your pressure washer. Features: ⚙️ Precision Detent System: Foam ratio, spray pattern, and rotation all click into place and hold, so your setting does not drift between washes. 🫧 Triple-Filter Foam Output: Three stages of filtration produce thick, buildable foam with even coverage across the panel. 🔧 Stainless and Rebuildable: Stainless steel internals handle long-term use, and the entire unit can be rebuilt instead of replaced. 🎛️ Tuned to Your Setup: Two orifices included, 1.1 and 1.25, plus 360 degree multi-point adjustment and a spray pattern that runs wide to narrow. Frequently Asked Questions What does the detent system actually do? It locks each adjustment into a click stop instead of a free-turning knob. Your foam-to-water ratio, spray pattern, and rotation hold their position, so the cannon performs the same every time you pick it up. Which orifice should I use, 1.1 or 1.25? Match it to your machine's flow. Lower-flow pressure washers generally do better with the smaller 1.1 orifice to build adequate pressure, while higher-flow machines run better with the 1.25. Both are included, so you can test which produces thicker foam on your setup. Can the foam cannon be rebuilt? Yes. The unit is fully rebuildable, so wear items can be serviced rather than forcing you to replace the whole cannon. Will it keep drawing soap as the bottle empties? Yes. The weighted pickup tube stays down in the solution as levels drop and as you tilt the cannon, which keeps the draw consistent instead of pulling air. What soap works best in it? We highly recommend Stinger Chemical Lemonlicious for netural pH, if you are really looking to rip dirt without scrubbing much then Stinger Chemical Body Tire & Wheel is the way to go. If you want the basic go-to for everyone then its Bubblicious. The triple-filter system builds thick foam, but the soap you load still sets the ceiling on foam quality.