QuickEpox Black 10-Minute Epoxy Glue

Pre-Order Now for a November Ship Date! BLACK EPOXY GLUE FOR TOUGH REPAIRS Use QuickEpox Black to make nearly invisible repairs to marine hardware, automotive components, equipment housings, tools and other dark-colored parts. Its nylon-reinforced formula creates flexible bonds that resist everyday impacts and chemical exposure. The epoxy gives you 5 minutes to mix and position before it sets in 10 minutes, then cures in 1 hour for light use to help reduce downtime. Allow 24 hours for full cure. ADHESIVE EFFECTIVE ON DIFFICULT SURFACES The high-viscosity formula fills small gaps and won’t sag during vertical or overhead repairs. Nylon reinforcement adds flexibility, helping the cured bond resist impact and chemical damage. QuickEpox Black becomes waterproof after full cure and blends into dark repair areas. Use it to bond wood, metal, fiberglass, glass, ceramic, tile, rubber, fabric and most plastics. Note: QuickEpox does not bond to polyethylene or polypropylene. EASY-TO-USE SYRINGE AND STIR STICK INCLUDED The dual syringe dispenses both components at a precise 1:1 ratio. Point the syringe upward and let trapped air rise before removing the cap, then dispense equal amounts and mix thoroughly with the included stick. Apply between 50–90°F and secure the bonded parts for up to 10 additional minutes as needed. Have leftover epoxy after your project? Pull the plunger back slightly to stop the flow, wipe the tips clean and replace the cap to save it for the next repair. Clean uncured epoxy with denatured alcohol. Cured epoxy must be removed mechanically. TOTALBOAT QUICKEPOX 10-MINUTE BLACK EPOXY ADHESIVE FEATURES Nylon-reinforced, two-part epoxy glue with a 1:1 mix ratio Sets in 10 minutes and cures in 1 hour for light use; allow 24 hours for full cure Bonds wood, metal, fiberglass, glass, ceramic, tile, rubber, fabric and most plastics Does not bond to polyethylene or polypropylene High-viscosity formula fills gaps without sagging Dries black to blend into dark materials and surfaces Waterproof after full cure and resistant to solvents and impacts Can be sanded, shaped, drilled or painted after curing Apply between 50–90°F Dual syringe keeps resin and hardener separate until ready to mix Accurately dispenses at a 1:1 mix ratio Includes a mixing stick for thoroughly combining both components Resealable cap helps prevent leaks and store leftover epoxy