Blumat BluSoak 3.0 Drip Tape

BluSoak 3.0 is a low-flow, emitter-style drip tape designed to pair perfectly with Blumat sensors. With 6-inch emitter spacing, it delivers deep, even hydration and excellent wicking throughout the soil. Operating best between 10–15 PSI, BluSoak 3.0 is the ideal choice for pressurized Blumat setups using a 1-bar pressure reducer or adjustable pressure reducer. It’s not intended for gravity systems, but in any pump-driven or city-water installation, it provides unmatched consistency and control. BluSoak 3.0 is a one-to-one retrofit replacement for the original white BluSoak 2.0 tape and has quickly become the favorite among commercial cultivators for its clog-resistant design, superior uniformity, and excellent value. Available Lengths: 10 ft, 20 ft, 40 ft, and 100 ft rolls ✔ 6-inch emitter spacing for even, controlled watering ✔ Low-flow output matched to Blumat’s flow rates ✔ Performs best at 10–15 PSI — perfect for pressurized systems ✔ Proven clog-resistant design tested in commercial grows ✔ Improved performance, reduced cost Important Installation Notes: BluSoak 3.0 must be cut through the emitters, not between emitters. Cutting between emitters can disrupt the engineered spacing and may result in uneven or non-functional water distribution. Always cut directly through an emitter to maintain proper performance. Make sure all Perma-Loc fittings are tightened fully to prevent leaks. For best results, use a pair of pliers or channel-Locks to hold the black body of the fitting steady, then use your hand to tighten the green collar until snug — this method typically gives you an extra ¼ turn versus hand-tightening alone. Even small leaks reduce system pressure and flow where it matters most, which can lead to inconsistent watering and poor Blumat performance.