FAAC 72840065 Rear Mounting Bracket and Plate

Rear Mounting Hardware for FAAC 400, 402, 422, and 415 Operators The FAAC 72840065 is a genuine OEM rear mounting bracket and plate set used to anchor FAAC hydraulic and electromechanical swing gate operators to the gate post or pillar. The set is compatible with the FAAC 400, 402, 422, and 415 operator families. Rear mount hardware carries the full reactive load from the operator during every open and close cycle, so a worn, bent, or corroded bracket can introduce misalignment, binding, and accelerated wear on the operator's piston and pivot points. Replacing the rear mount with the correct OEM set restores proper geometry and load transfer between the operator and the post. The bracket and plate are supplied in a zinc-plated finish for corrosion resistance in outdoor installations. Key Features Genuine OEM FAAC rear mounting bracket and plate set Compatible with FAAC 400, 402, 422, and 415 swing gate operators Anchors the operator to the gate post and transfers cycle load during open and close travel Restores correct mounting geometry when the original bracket is bent, worn, or corroded Zinc-plated steel construction for outdoor corrosion resistance Technical Specifications Part Number: 72840065 Component Type: Rear mounting bracket and plate set Compatible Operators: FAAC 400, 402, 422, 415 Material: Zinc-plated steel Application: Swing gate operator rear post mount Manufacturer: FAAC Conclusion The 72840065 is the correct rear mount hardware for FAAC 400, 402, 422, and 415 operator installations. Inspect the operator's rear pivot pin and bushings at the same time the rear mount is replaced, as wear to these components is often concurrent. Confirm the bracket geometry matches the original installation A and B mounting dimensions before fastening to maintain correct gate travel.