35mm × 28mm × 28mm End Feed Reducing Tee (Reduced End & Branch) — Copper

The 35mm × 28mm × 28mm End Feed Reducing Tee connects 35mm and 28mm in line (the run) with a 28mm branch at 90°. A reduced end-and-branch tee — off the 35mm inlet, one run end steps down to 28mm and the branch is a reduced 28mm. Soldered capillary joints on all three ends. Manufactured to BS EN 1254-1 and fits copper tube to BS EN 1057. This is a reduced end-and-branch tee — a run end (28mm) and the branch (28mm) are both reduced from the 35mm end. Also known as: reducing tee, end and branch reduced tee, double reducing tee, unequal tee, 35x28x28 tee, endfeed reducing tee. Manufactured to BS EN 1254-1 for capillary (solder) fittings Reduced end-and-branch tee — 35mm × 28mm × 28mm Fits copper tube to BS EN 1057 WRAS approved Solder and flux required — not supplied Sold individually — buy exactly what the job needs Suitable for hot and cold water and heating services End feed means a capillary joint: clean the tube and fitting, apply flux, heat evenly and feed lead-free solder to the mouth of the fitting until a ring forms. See our guide: How to solder end feed fittings. Also in this range: equal tees, couplers and the full end feed range. Ordering for a whole job? Use the bulk fittings matrix.