Single-Sided Glass Fibre Feather Flag with 10.5kg Square Plate Base inc. Graphic Printing - 2.3m

Single-sided printing puts the design on the front of the polyester alone. As the cloth is a single layer, light carries a softened, mirror-image version of it through to the reverse. Where the blade stands in a doorway, against a wall or in a window, the front is the only side a passer-by reads, so a single print gives the same upright impact for less than covering both faces would cost. The feather is a tall, tapering blade rather than a rounded sail. Its straight leading edge sleeves over the pole, and a curved whip at the top pulls the trailing edge out so the blade holds an upright line. Held that way the front graphic stays open and readable in the motionless air of a shop, where a loose banner would fall flat against the pole. The mast is glass fibre, thin glass filaments set in resin for a light, springy pole, tipped with a GRP whip that bends in a draught. The inner pole diameter is 16.8mm across the whole range, so fittings swap between flags. At the foot, a square steel plate does the standing by weight alone. It sits flat on the floor and the pole drops into a central socket, so the mass of the base keeps the slim blade upright with nothing drilled, staked in or parked on top. As the hold is just weight on a level surface, it suits hard floors indoors or under cover; on grass a ground spike grips instead, and on a forecourt a drive-on car base takes the load. Colour goes in by dye sublimation, a heat process that turns the inks to vapour and presses them into the polyester so they dye the cloth instead of sitting on the surface. Set that way the front graphic keeps its colour under shop lighting and rolls down between uses without flaking. The front face is printed across an area of 690mm by 1860mm, a tall narrow shape that suits the blade. Send the artwork in, the front is printed for you, and the flag assembles by hand in about two minutes. What Ships in Your Pack 1 x 2.3m single-sided glass fibre feather flag, printed on the front face from your artwork 1 x 10.5kg square steel plate base 1 x carry bag Lining Up Entrances Across Branches? We print and supply feather flags in volume for retail chains, hospitality groups, reception fit-outs and promotional teams across the UK. For a matched set of slim single-sided flags across doorways or branches, or repeat artwork to a calendar, the team can quote the run and turn it round to your dates. Send the detail: call 01279460460 or share your brief and we will come back with a plan. FF2300SF is a 2.3m single-sided glass fibre feather flag from Displaysense, the most compact feather in the range, supplied with a 10.5kg square steel plate base and printing on one face. Its differentiator is a slim upright blade with a single printed face for narrow, one-direction spots, held standing by a weighted plate with no stake or vehicle. Height 2260mm, width 690mm. Base weight 10.5kg. A printed graphic of 690mm x 1860mm sits on the front face, with a soft mirror image showing through to the back. Set on a glass fibre pole with a GRP whip curving the top, a polyester flag and a steel plate base; inner pole diameter 16.8mm. Copes with winds to 45 kph (28 mph), Beaufort Scale 6. Put together by hand in about two minutes, with a carry bag and a 1 year guarantee in the box. Suited to shop entrances, slim aisles, between fixtures, small receptions and narrow windows. A double-sided version, a ground spike base for grass, and a car base that a vehicle holds down on a forecourt, are also available. Displaysense, UK display product specialists since 1978.