ESP32-C3 OLED Screw Terminal Base with LiPo Charger

A base for the ESP32-C3 OLED with screw terminals, for wire that has to stay put. The board plugs into the two black sockets in the middle, each of its sixteen holes comes out to its own terminal, and a LiPo connector, charger and power switch are built in. Highlights Screw terminals. Two blocks of eight 3.5 mm ways, one down each side. Battery power. JST PH 2.0 connector, TP4054 charger and a slide switch. Plug in USB with the switch ON and a cell connected to charge it. Battery monitor. An open solder jumper connects a divider across the cell to GPIO 2, so a sketch can read its own battery level. Two 4.8 mm mounting holes, 16 mm apart. In the box 1 × ESP32-C3 OLED screw terminal base, terminal blocks fitted The ESP32-C3 OLED board, the battery and cables are not included. Specifications Terminals: 2 × 8 screw, 3.5 mm pitch Battery: JST PH 2.0, single 3.7 V lithium cell with a protection circuit Size: 44.5 × 32.5 mm, 10.3 mm tall from the underside Seat the board with its antenna at the power-switch end and its USB-C socket at the battery-connector end.