Knuckle Duster Made from 6061 T6 Aluminum with Shattered Crest

The Knuckle Duster Made from 6061 T6 Aluminum with Shattered Crest is a four-finger EDC knuckle duster machined from aluminum alloy and sealed in an anodized matte olive drab finish. A cracked crest pattern is laser-engraved across the face, breaking the flat panel into a web of fractured lines that shift with the light. The outer rim follows a scalloped silhouette, so the lower edge steps in soft waves instead of running in one straight line. The color is not paint sitting on top: it comes from the anodized layer itself, which forms inside the metal.The frame measures 116 × 66 × 15 mm overall, with four rounded openings sized at approximately 25 × 29 mm each, and the complete piece weighs about 132 g. Chamfered edges run along both faces of the rim, so every border meets the side wall with a beveled step rather than a sharp corner. The side wall carries the same matte texture as the face panels, and the wave pattern of the silhouette continues around the full lower edge. At this weight the duster sits dense in hand while staying light enough to pocket through a full day out.Placement is straightforward on a shelf, desk tray, or EDC board, where the olive tone sits quietly against both dark fabric and pale stone. The laser-engraved cracked crest reads clearly at arm’s length yet stays understated up close, and the scalloped silhouette gives the piece a recognizable outline from any angle. A wipe with a dry cloth after handling is all the anodized surface needs to keep its even, low-gloss look.Key Features Shattered crest identity: a laser-engraved cracked crest spreads across the face panel in fractured lines Anodized olive drab: the matte green-gray color is part of the aluminum itself, not a coating applied on top Scalloped frame: the outer silhouette steps in waves along the lower edge, with chamfered borders on both faces Four-finger layout: rounded openings line up across the face in the standard four-finger arrangement Pocket-scale weight: dense in hand without weighing down a pocket or pack Specifications Material: 6061-T6 aluminum alloy Finish: Anodized matte olive drab Dimensions: 116 × 66 × 15 mm Finger holes: 4 holes, approx. 25 × 29 mm each Weight: about 132 g Type: Four-finger EDC knuckle duster Design: Laser-engraved cracked crest; scalloped silhouette; chamfered edges Frequently Asked QuestionsQ: What is the body made of?The frame is machined from aluminum alloy and finished with an anodized matte olive drab surface. The color sits inside the anodized layer, so it will not peel the way paint does.Q: How does the crest design look in person?The cracked crest is cut by laser into the face panel, leaving a web of fractured lines across the olive surface. It reads clearly from a distance and stays understated up close.Q: Will the frame fit a four-finger hold?The openings run in the standard four-finger layout across the face. Each one is rounded and generously sized, so the frame sits evenly when placed over the hand.Q: Is it convenient to carry day to day?The piece stays light enough for a pocket or pack, and the chamfered edges keep every border smooth against fabric. A dry cloth wipe after handling keeps the matte finish even.Q: How should the surface be maintained?The anodized finish needs little more than an occasional wipe with a dry cloth. Avoid abrasive pads, and the low-gloss olive surface keeps its uniform tone.Set it on a shelf or slide it into a pocket, and the fractured crest lines plus the wave-stepped rim keep the piece recognizable from any angle.