Ai-1204 Ball Joint Delete™ System 05+ Ford F250/350 & Ultimate Duty 60 1.5 degree

The Ai-1204 is a press-fit kit with a same install method as a factory joint. It features a split-tapered bushing which expands as preload is added to the assembly ensuring a precise fit. The customer can trim the top flange of the bushing based on caster/camber needs, the kit includes instructions on setup and trimming. 7075 Aluminum Split-tapered bushings in 1.5 degree Huge 1.625" Teflon lined Spherical Bearings with 7/8" bores All assemblies are greased and lubricated 7/8″ 4140 Hardened custom spec bolts 7/8″ Low profile locknut Ideal for trucks using 2-3" lifts/leveling kit with stock leaf springs/radius arms **** INSTALLATION INSTRUCTIONS CLICK HERE **** Fitment: The Ai-1203 is the perfect solution to a stock truck that has a 2-3" lift/level kit when paired with the stock radius arms or leaf springs. American Iron uses this exact kit in its 2016 Ford F250 shop truck with a leveling kit, towing cross-country. Lifting the truck means caster is lost, but can be added back via the 1.5 degree bushing in our kit. Stock lower ball joints see less failures but are susceptible to “push out.” This happens when a shaft breaks and pushes the joint out the bottom of the knuckle. The lower system uses the same basic design as the upper, with a 1 piece stud with taper to match the tapered hole in the knuckle. When swapping a donor axle into say, a Jeep you can run into a compromise between driveline angle and ideal caster. Have that pinion pointed directly at the transfer case output, but only have 4 degrees of caster? Use the 1.5 degree provided in the Ai-1203 to increase that caster to 5.5 degrees and you have the absolute best of both worlds- a perfect driveline angle, ideal caster, AND an unbreakable joint on top of it. ABSOLUTELY NO ONE ELSE IN THE INDUSTRY PROVIDES THIS LEVEL OF STRENGTH WITH ADJUSTABILITY. What is a Ball Joint Delete™ System and why do you need it? Learn more from American Iron Offroad™ founder Josh Dodsworth: We stand by the quality and durability of our products. We will warranty parts found to be defective. The spherical bearings, specifically, also carry a 2 year or 30,000 mile (whichever comes first) warranty. We cannot warranty parts that have been damaged due to improper installation. We will, however, work with our customers on replacing individual parts should they be needed. Don't take our word for it, hear from real world drivers that use our products and put them to the test everyday. Tony Pellegrino Founder of GenRight Offroad Jon Schaefer Founder RPM Extreme Scott Durkin Driver of the Trail Reaper Roger and Amber Betancourt