CSS Touring® Quick Release Awning Brackets to Standard Roof Top Tents (Set of 3) | Pre Order (Copy)

CSS Touring® Quick Release Awning Brackets (to suit our Standard Roof Top Tent Model) Brackets can also be made fixed if you are not wanting to use them as quick release. Stock Levels: Melbourne Store - Out of Stock Until Further Notice Brisbane Store - Out of Stock Until Further Notice Please kindly note, the ETA is subject to change due to unforeseen delays. Awning Brackets suit the below Tent Model: CSS Touring Standard 1.3 Roof Top Tent CSS Touring Standard 1.4 Roof Top Tent Included in the Bracket Kit: 3x Awning Brackets 2x Corner Braces All Required Hardware Please note, it is mandatory that your awning is tied down every time it’s in use if mounted directly to the side of your rooftop tent. Also kindly note that once an awning is mounted with these brackets to one of our rooftop tents, there won’t be enough clearance to open and close the side latch. In this case, you will simply need to remove the side latch to run the awning mounted directly to the side of the rooftop tent. This is completely fine to do, you’ll just need to be mindful, as you normally would to make sure the canvas is always tucked in properly when closing the tent so there’s no fabric caught or pinched in the seal. Also, as usual, you’d need avoid overfilling the tent with bedding to ensure everything closes smoothly. Only suitable for our Standard Rooftop Tent model. Not suitable for our X/Pro Rooftop Tent models.