HL36P08 36-Module 8-Way Pre-Wired 3-Phase Distribution Board SPD 40A RCD IP30

The HL36P08 is a prefabricated, pre-wired and tested 36-module distribution board with integrated surge protection, supplied ready to connect. It pairs a Hager Volta flush IP30 enclosure with Legrand RX³ protection and a Legrand Type 1+2 surge protective device (SPD): a 4-pole 40A 30mA Type A RCD feeding 8 single-pole B16 circuits, with the SPD guarding the installation against lightning and switching surges. Built for three-phase 230/400V installations in homes, apartments and light commercial premises, it arrives fully wired with busbar, neutral and earth bars done, leaving 20 spare ways for future circuits. Technical specifications Part number: HL36P08 Enclosure: Hager Volta VU36NC, flush (recessed) wall mounting Module capacity: 36 (3 rows of 12 x 18mm) Protection rating: IP30 Dimensions (approx.): 630 x 348 x 98 mm (H x W x D) Door: white hinged steel door with quarter-turn latch and technical-data label Surge protection: Legrand 412257 SPD, Type 1+2, 3P+N, Iimp 8 kA/pole (IEC 61643-11) Main protection: Legrand RX³ 402075 RCCB, 4-pole, 40A, 30mA, Type A, 400V Outgoing protection: 8 x Legrand RX³ 419136 MCB, 1-pole, B16, 6kA, 230V Modules used: 16 of 36 (20 spare ways for future circuits) Internal wiring: 10 mm² H07V-K with insulated ferrules; Hager KDN363A 3-phase, 12-module busbar comb Distribution bars: separate neutral (blue) and protective earth (green/yellow) terminal bars Supply: three-phase, 230/400V AC, 50Hz Features and benefits Prefabricated, pre-wired and tested: no internal assembly, busbar cutting or comb wiring on site Type 1+2 SPD diverts lightning and switching surges at the service entrance, protecting downstream equipment Type A RCD trips on both AC and pulsating DC residual currents, covering circuits with electronic loads that a Type AC device would miss 30 mA sensitivity adds protection against electric shock B16 curve breakers suit general lighting and socket circuits with low inrush 20 spare module ways for adding circuits later Flush enclosure finishes level with the wall surface Branded protection throughout: Hager Volta enclosure, Legrand RX³ devices Applications New three-phase consumer units in houses and apartments Renovation and rewiring projects Light commercial and office sub-distribution Replacement of older fuse boards Installations needing surge protection, such as rural or overhead supplies and sites with sensitive electronics Built from components compliant with IEC 61008-1 (RCD), IEC 61643-11 (SPD) and IEC 60898-1 (MCBs); enclosure to DIN 43870, IP30 per IEC 60529. Also known as: surge protected pre-wired 3-phase consumer unit 36 module, populated distribution board 40A 30mA, Hager Volta Legrand RX3 board, flush mount fuse board 3 phase, ready wired distribution board, Type 1+2 SPD distribution board