Model Y Juniper Rear Diffuser 2.0 ABS Sporty Style Lower Bumper Lip

【Compatibility】Compatible with Tesla Model Y Juniper Premium 2025.03+. Note: Not Compatible with Model Y Juniper Standard or Performance Trims. 【Durable ABS Construction】 Made from durable, lightweight ABS, the EVBASE rear diffuser offers impact resistance without adding unnecessary weight. The matte black finish coordinates with the factory rear bumper trim for a clean, consistent look. 【Three-Piece Design】A center section and two side pieces add definition across the lower rear bumper. Raised fins give the rear a more structured, sporty appearance, while the separate sections follow the bumper’s shape for an integrated look. 【Precision Fit】Designed for the Tesla Model Y Juniper using precision 3D scanning, this rear diffuser follows the original bumper contours for a close fit. Its low-profile design adds a sportier look without making the rear end appear bulky or overdone. 【No Drilling Installation】 Installs with pre-applied 3M automotive tape, with no cutting or drilling needed. Clean and dry the mounting surface, check the alignment of each piece, then peel off the backing and press firmly into place. The tape provides a secure hold when applied according to the installation instructions. An Add-On for Your Existing Bumper The diffuser mounts directly onto the original lower bumper, so there’s no need to replace the entire bumper assembly. The center and side sections cover selected areas while leaving the surrounding factory trim exposed. This gives the lower rear a more defined appearance while keeping the original bumper and its overall layout in place. FAQs Q1: Do I need to remove my rear bumper to install it?+ A1: No. The three pieces attach to the outside of the existing lower bumper using pre-applied 3M automotive tape. No bumper removal, cutting, or drilling is required. Q2: Will it cover my license plate or rear reflectors?+ A2: No. When correctly positioned, the pieces sit below the license plate and rear reflectors, leaving both visible. Q3: What should I do before sticking the pieces on?+ A3: Clean and dry the mounting areas thoroughly, removing any dirt, wax, or grease. Test-fit all three pieces before peeling off the tape backing, then press firmly along each mounting surface. Follow the installation guide for temperature requirements and how long to wait before washing.