Barjack Raven 3" Backing Plate

3" Threaded Backing Plate for the Raven This is the threaded 3-inch hook-and-loop backing plate for the Barjack Raven cordless DA polisher, sold on its own as a replacement or a second plate. It threads onto the Raven's spindle and is the interface between the tool and whatever pad you put on it, which makes it quietly responsible for a lot of what the machine feels like in your hand. Backing plates are a wear item that almost nobody replaces on time, because they fail gradually rather than suddenly. The hook-and-loop face wears down, grip weakens, and pads start walking under load or coming off entirely at speed. The foam cushion compresses and stops letting the pad conform, so your finish gets less consistent and you cannot work out why. Meanwhile the plate edge takes damage from contacting panels and badges. A fresh plate restores pad hold, cushion, and balance at once. Pairs with the Buff and Shine microfiber pads recommended for this tool, and more options in backing plates. What Makes it Great: 🔒 Restores Pad Grip: Fresh hook-and-loop holds the pad where you put it, which matters most on edges and contours where a slipping pad is both a finish problem and a safety one. 🎯 Correct Thread for the Raven: Threads onto the Raven spindle as designed, so the plate runs true instead of introducing wobble the tool then transmits to your hand. 🧈 Cushion That Still Works: A compressed cushion stops letting the pad conform to curvature. A new plate brings back the compliance that makes a 3-inch machine finish cleanly on contours. 🔄 Worth Owning Two: Dedicating one plate to compounds and another to glass or coating work keeps abrasive residue out of the hook-and-loop you use for finishing. Frequently Asked Questions How do I know when a backing plate needs replacing? Check the hook face against a new one and the difference is usually obvious. Signs it is done: a pad that twists or walks under moderate pressure, a pad you can peel off with almost no resistance, visible flattening or glazing of the hooks, a cushion that no longer springs back when you press it, or chewed and chipped edges. The tell most people notice first is vibration that was not there before, which usually means the plate has deformed and is no longer running true. What size pads should I run on a 3-inch plate? Pads should be slightly larger than the plate, not the same size. You want a small amount of pad overhang so the foam edge can roll and conform on curves and so the plate rim never contacts paint. On a 3-inch plate that generally means 3.5-inch or 4-inch pads depending on the pad's construction. Matching a 3-inch pad to a 3-inch plate puts the hard plate edge right at the working surface, and that is how you put a rim mark in a bumper. Why does my pad keep walking or flying off? Almost always the plate rather than the pad. Worn hook-and-loop simply cannot hold against the lateral force a dual action generates, and it gets worse as the pad heats up and the adhesive side softens. Other contributors: compound or polish residue packed into the hook face, a pad that was not centered when installed, or running too much pressure for the pad size. Clean the hook face, center the pad deliberately, and if grip is still weak the plate is the answer. Should I own more than one plate? If you use the Raven for more than one kind of work, yes. Compound and polish residue works its way into the hook-and-loop and transfers to whatever goes on next. Keeping a dedicated plate for cutting and a separate one for glass polishing, coating application, or finishing means you are not carrying abrasive into a step that is supposed to refine. Same reasoning as keeping glass towels out of the dressing pile. Will it fit other 3-inch polishers? Only if the thread matches. Diameter is not the compatibility spec on a threaded plate, the spindle thread is, and mini polishers across brands do not share one standard. Check the thread on your machine against this plate before ordering rather than assuming a 3-inch plate fits any 3-inch tool.