AIC ADV80 CAN Gauge

Introducing the ADV80 CAN Gauge by AIC Designed and manufactured in New Zealand, this is more than just a display! It allows users to control, protect and monitor their performance vehicles with a singular device. Compatible with 10 common aftermarket ECU platforms, including Link, Haltech, Maxx Etc. Replaces or supplements traditional gauges for a clean and simple digital alternative by reading 46+ live data points directly from the engine control unit (ECU/ECM) via CAN bus and displaying it on a vibrant full colour, sunlight readable 80mm IPS touch screen. Access data via dedicated, Boost, Lambda and Tachometer screens as well as three user configurable multi gauge displays and two user defined custom gauges on the fly, via the touch screen. Set warnings such as an engine check light, manifold pressure, lambda, shift light etc. Allows users to make quick adjustments to parameters such as boost control and traction control eliminating the need for separate switches or keypads in many applications. Features a unique dual point Oscilloscope display for quick fault finding without needing a laptop! Set a 4 digit pin code to lock your ecu adding another layer of security, particularly useful in race vehicles with no traditional ignition key. The housing feature a 52mm diameter rear section allowing easy fitment to common gauge holders, but the screen is much larger than most other options at 80mm. Key Features: Anodised 6061 Aluminium Housing 46+ Data Points Dim Display Input ECU Security Fault Code Display Dual Point Data Scope Adjustable Units and Scaling Adjustable Warnings Adjust Boost Level Adjust Traction Control Enable/Disable Antilag Enable/Disable Launch Control User Selectable Screens: Boost Gauge Lambda Gauge (Dynamic) Tachometer Gauge Multi-Gauge A Multi-Gauge B Multi-Gauge C User Defined Gauge 1 User Defined Gauge 2 Fault Code Monitor Show All Data Oscilloscope Control ECM Security Settings Compatible with: Link Engine Management Haltech Maxx Ecu Emtron Ford Barra Hondata ECU Masters Motorsport Electronics UK Megasquirt Edelbrock Available CAN Data: Accelerator Pedal Position Exhaust Gas Temperature 3 Gear Position Manifold Pressure Barometric Pressure Exhaust Gas Temperature 4 Ignition Angle Manifold Peak Pressure Voltage Exhaust Gas Temperature 5 Inlet Cam Position Oil Pressure Coolant Pressure Exhaust Gas Temperature 6 Inlet Cam 2 Position Oil Temperature Coolant Temperature Exhaust Gas Temperature 7 Injector Pulse Width Throttle Position ECU Temperature Exhaust Gas Temperature 8 Injector Duty Cycle Transmission Temperature Engine Speed Fuel Pressure Injector Duty Cycle Secondary Vehicle Speed Ethanol Content Fuel Temperature Injector Differential Pressure Wheel Speed – Left Front Exhaust Cam Position Fuel Trim Long Bank 1 Inlet Air Temperature Wheel Speed – Left Rear Exhaust Cam 2 Position Fuel Trim Long Bank 2 Lambda Wheel Speed – Right Front Exhaust Gas Temperature 1 Fuel Trim Short Bank 1 Lambda 2 Wheel Speed – Right Rear Exhaust Gas Temperature 2 Fuel Trim Short Bank 2 Lambda Overall Fault Codes * The gauge can only display data that is available from the engine control unit. Connection The Gauge comes with a pre terminated 6 pin harness, use the colour code below for connection. The gauge requires a 0.5A fused supply and 12V nominal DC voltage. 01 – Black – Ground 02 – Red – Ignition 12V Supply 03 – Orange – Dim Display 04 – Yellow – CAN High Signal 05 – Green – CAN Low Signal 06 – Brown – No Connection Mounting 2x M3 tapped holes are provided on the housing back for custom bracket adaption if required. The holes are 44mm across centers. The gauge also has a 52mm body for mounting into standard gauge holders. Further Information Is available via the Wiki section of the AIC website.