Strange Pro II Rear Brake Kit for One-Piece Aluminum Dragster Housing 2 Pc Rotors, 4 Piston Calipers & DRM-35 Metallic Pads
THESE BRAKE KITS ARE DROP SHIPPED FROM STRANGE ENGINEERING Part Number: B1150WCM2 Designed Specifically for Drag Racing Pro II Rear Brake Kit For Strange one-piece aluminum Dragster housing H1151 / H1161/ H1152 /H1162 Requires • Ball style axle bearings • 2.832″ brake offset Pro II Kit With 2.332″ Offset Is Not Available Two Piece Floating Slotted Steel Rotors – B2794L / B2794R • Isolates rotor from hat section • Eliminates pulling forces that can result in cupped rotors • Slots improve air flow, assist in warpage prevention and reduce weight • 4 1/2″, 4 3/4″ & 5″ Uni-Lug bolt circles for both 1/2″ & 5/8″ studs Four Piston Directional Calipers – B5002 / B5004 • Aluminum bodies drastically reduce weight • 1.625″ & 1.750″ pistons vary pressure decreasing pad taper • Stainless steel pistons resist corrosion • Anti-rattle clips reduce brake pad vibration and noise DRM-35 Metallic Brake Pads – B5020 • Provides high resistance to brake fade • Recommended for vehicles going over 150 MPH in the 1/4 mile • Maintains decent starting-line cold holding capabilities • May leave pad residue on rotors when not using parachute • While common, it’s recommended to remove when installing new pads Aluminum Caliper Mounts • Billet one piece design • Eliminates bolts, spacers & nuts that require periodic maintenance Housing End Bolt Kit • Provides additional components not supplied in most aftermarket kits Need More Wheel Clearance? Evolution 4 Low Profile Caliper Option – OPRB10 Want Billet Calipers? Evolution 4 Billet Caliper Option – OPRB07 Brake Hoses and Lines Are Not Included Calipers are tapped 1/8″ NPT and supplied with a straight male 3 AN fitting Use Teflon® tape or liquid on the pipe threads of the fitting Leave a few threads from the tip uncoated This will avoid depositing material inside the caliper Torque fitting to 25 ft lbs Related With DTC-30 semi metallic pads – B1150WC2