DSM & Humboldt Dumblifier

THE DUMBLIFIER WHY THE DUMBLIFIER? For decades, guitarists around the world have dreamed of capturing the magic of the mythical Dumble Overdrive Special. Until now, the only way to approximate this experience has been through digital modeling—solutions that may reproduce the sound, but always fall short of replicating what truly makes these amps legendary: the feel under your fingers. The Dumblifier Overdrive Special by DSM Humboldt Electronics breaks that barrier. By using our proven analog amplifier modeling technology, we have not only recreated the tone but also the unique compression and touch response that makes every note bloom, sustain, and sing—just like on the original amps. WHAT SETS US APART? Analog accuracy: Unlike digital processors, the Dumblifier responds organically to your playing dynamics, delivering the unmistakable “punchy compression” and smooth sustain that Dumbles are known for. Daniel Schwartz CPO & Founder BEYOND BOUTIQUE LIMITATIONS Until now, the few available alternatives were extremely expensive and produced only in limited, made-to-order quantities, never intended for mass availability. RIGHT AS "THE REAL THING" Beyond studying schematics, recordings, and every available piece of information, we had the rare opportunity to spend time with a genuine 1970’s Dumble ODS in Tokyo, Japan. Thanks to a devoted DSM Humboldt fan, we were allowed to test and analyze this priceless relic, an experience that gave us invaluable insights to fine-tune the Dumblifier’s design. TRUE VERSATILITY Other so-called “Dumble-style” pedals are meant to run in front of amplifiers, so the final tone depends mostly on the amp itself. The Dumblifier, however, goes further—it can operate as a complete analog amp replacement with cab-sim and stereo features, or as a two-channel overdrive pedal in front of any rig. Its TRS outputs with cab-sim bypass make it extraordinarily flexible. All-in-one solution: With stereo FX loop, stereo reverb, cabinet simulation, and DI outputs, the Dumblifier is equally at home on stage, in the studio, or in your practice setup. PLUG & PLAY CONVENIENCE Packed into a pedal format, offering all the features gigging and recording musicians demand—without the cost or fragility of a boutique tube amp. MULTI-STAGE STEREO REVERB After the FX loop, a stereo reverb effect is applied to the signal. You can control the amount of reverb with the REVERB knob in the front of the pedal, and select 3 types of reverb (Room, Ethereal, and Plate). The Reverb can be switched On and Off with the REV/PAB footswitch when the footswitch function switch is on the “REV” position. DUMBLIFIER: TECH SPECS HEAVY DUTY, custom-made anodized aluminum enclosure with a sandblasted finish.Wooden side panels add a unique touch and premium feel. LOW POWER CONSUMPTION: 200mA / 9V center negative COMPACT SIZE: 13,5x11,5x6.5 cms -- 5,5x 4,4x2.5 inches Weight: 620 grs. -- 1,3 pounds Power supply requirements: Voltage: 9V DC regulated Connector: 2.1mm DC jack, Center negative Current consumption: 200mA Recommended supply current: 250mA and up Input Impedance: Input: 1Meg Ohm L & R return: 1Meg Ohm Output impedance: Send: 1K Ohm Unbalanced Outputs: 4.7K Ohms Balanced Outputs: 100 Ohms Headphone amp specs: Power: 135mW into 32 Ohms. * Use with 16, 32, 64 and 96 Ohm Headphones. * Loss of power can occur with higher impedance headphones.