The Shimicoat T-Bar Floor Applicator lays down epoxy, polyurethane, acrylic coatings, sealers and primers in an even, streak free film across large floor areas. The zinc plated steel frame threads onto any standard extension pole, and the foam sleeve pulls off and replaces in seconds when it is spent.Available in 12 inch (305mm) and 18 inch (457mm) widths. The frame and the sleeve are sold separately, so choose the part and the size you need above. Most installers keep one frame and a stack of spare sleeves, since the sleeve is disposable and the frame is not.Specifications Widths: 305mm (12 inch) or 457mm (18 inch) Frame material: zinc plated steel Sleeve material: synthetic fibre and nylon foam blend, approx 50 to 55mm thick Handle connection: standard threaded socket, suits 22 to 25mm extension poles Weight: approx 600g (18 inch) or 400g (12 inch) Working temperature: 5C to 40C Suitable for Epoxy, polyurethane and acrylic floor coatings Water based and solvent based sealers, primers and densifiers Concrete, cement screeds, self levelling compounds, terrazzo, stone and timber floors Using itPour the mixed coating onto the floor in manageable sections and spread it with steady pressure, keeping a wet edge as you go. Clean the frame straight after use with water for water based products or xylene for solvent based products. Sleeves are disposable, pull them off with pliers and bin them rather than trying to clean them.Full details are in the technical data sheet under Downloads on this page.