SCS F5 & GEN5 Center Caps - NEW

Center caps for your Stealth Custom Series F5/Gen5 wheels. Center caps are made of PC-ABS. These caps have a shallow recessed face for those wanting a sleek simple look to flow with your SCS, or customize it with your own decal/badge Sold individually (ie: Choose QTY 5 for total of 5 wheels) - BADGES ARE NOT PREINSTALLED ON THE CAPS Fitment: 106.7mm bore Fits front and rear wheel positions, with or without wheel spacers F5 Compatibility DOES IT FIT? SIZE BOLT PATTERN SPACING/OFFSET CENTER BORE NO 16 x 8.0 5 x 150 4.90"/+10 110.1 YES 16 x 8.0 6 x 139.7 3.50"/-25 106.1 YES 16 x 8.0 6 x 139.7 4.50"/+0 106.1 NO 17 x 8.0 5 x 114.3 5.30"/+20 60.1 NO 17 x 8.5 6 x 139.7 5.50"/+20 95.1 YES 17 x 8.5 6 x 139.7 4.30"/-10 106.1 YES 17 x 9.0 6 x 139.7 3.50"/-38 106.1 NO 18 x 9.0 6 x 139.7 5.50"/+12 95.1 NO 18 x 9.0 5 x 150 6.00"/+25 110.1 GEN5 Compatibility DOES IT FIT? SIZE BOLT PATTERN SPACING/OFFSET CENTER BORE NO 17 x 8.5 6 x 139.7 5.50"/+20 95.1 YES 17 x 8.5 6 x 139.7 4.30"/-10 106.1 YES 17 x 9.0 6 x 139.7 3.50"/-38 106.1 CAP Installation: The caps have a tight fitment tolerance for installation. For best results, make sure the 3M double back tape is being adhered to a completely clean and dry surface. When installing onto the wheel, maintain a flat plane parallel to the face of your rim while pressing the caps into the center bore. BADGE Installation: Ensure that the center dimple on center cap does not have a raised point. May be necessary to knock off the point on the center dimple that is caused from manufacturing for a clean look. For best adhesion, make sure the adhesive is being adhered to a completely clean and dry surface. Butt up one end of the badge to the center cap recessed face and center the rest of the edge. Lightly lay the badge down and apply pressure only to the center of the badge. From the center, apply pressure outwards to push any air that may be underneath. Peel protective film off face of the badge