CTS 500k No-Solder Push/Pull, Split Shaft, Ground Wires Added

This is our PP01 solder-free push/pull pot with ground wires added. The CTS DPDT push/pull switch can be used for coil splitting, phase reverse, series/parallel and more, and our screw-down terminal block means no soldering at all: insert the wire, tighten the screw, done. Specs Solder free! Ground wires added 500k audio taper (logarithmic) Split shaft, 24 teeth (for push-on knobs) 3/8-32 SAE bushing thread 1/2" thread length, long enough for rear-routed guitars Screwdriver included 15/16" body diameter Details The ground wires make this version truly solder-free. If your control cavity isn't shielded, there's nothing to ground the pot to, and these wires give you that ground without soldering. Most wiring layouts also need a ground connected to one or more slots on the terminal block, and the wires take care of that too. The pot is designed for 24-tooth push-on plastic knobs. We also include a brass sleeve that may be slipped over the pot shaft if desired, turning the split shaft into a quasi 1/4" solid shaft. You would use this if you intend to use setscrew knobs (which will need to be drilled 1/4", not 6mm). Includes Pot, with ground wires added 6" black and white wires, for jumpers where several connections share one slot Small screwdriver for the terminal screws Mounting hardware for top-rout and rear-rout installs Brass sleeve (see details)