Opel C20NE Throttle Body Adapter for Rover MG Manifold – 55mm Intake Adapter

Opel C20NE Throttle Body Adapter for Rover MG Manifold – 55mm Intake Adapter This throttle body adapter is designed to fit a 55 mm Opel C20NE throttle body to a Rover / MG intake manifold. It is a useful part for custom intake conversions, engine swaps, or throttle body upgrade projects where the Opel C20NE throttle body needs to be mounted to a compatible Rover or MG manifold. This is a custom adapter part and should be installed by someone who understands intake fitting, throttle body alignment, gasket sealing, and engine bay clearance. ⭐ Features Designed for 55 mm Opel C20NE throttle body Adapts Opel C20NE throttle body to Rover / MG manifold Useful for custom intake conversion projects Suitable for engine swap or custom throttle body setups Simple adapter design for clean mounting Strong and rigid construction Designed for automotive engine bay use Good option for custom Rover, MG, or Opel-based builds 🔧 Fitment & Installation Main compatibility: Opel C20NE 55 mm throttle body Rover / MG intake manifold applications Application: Throttle body adapter Intake manifold conversion adapter Important fitment note: This adapter is intended for custom conversion use Please compare your throttle body, manifold bolt pattern, gasket surface, and available clearance before ordering Fitment may vary depending on manifold version, throttle body version, engine setup, and modifications This is not a complete conversion kit Throttle body, manifold, gasket, bolts, sensors, cables, clamps, and other hardware are not included unless specifically stated Installation notes: Test fit the adapter before final installation Check throttle body alignment before tightening Use a suitable gasket or sealant where required Make sure the throttle plate opens freely and does not contact the adapter or manifold Check for air leaks after installation Installation should be carried out by someone who understands custom intake and throttle body fitting 🖨 Material & Print Quality Printed in ASA only Heat-resistant – suitable for engine bay use Strong and rigid construction Designed for custom automotive intake applications This is a 3D-printed part. Minor layer lines or surface marks may be visible. Optional light sanding or painting is recommended for a perfect cosmetic finish. 📦 Included 1× Throttle Body Adapter Printed adapter only Attribution: Original design by Łukasz Nowakowski.