Hydraulic Pendant Switch Wire Harness

Replacement Hydraulic Pendant Switch Wire Harness Drop-In Wire Harness for Hydraulic Lift Pendant Controllers This wire harness is the replacement component for your hydraulic pendant switch. Designed to restore communication between the manual controller and the hydraulic lift system, the assembly provides the wiring pathways needed to transmit directional signals directly to the hydraulic power unit. The exterior features a thick protective jacket that shields the internal wiring from friction and daily wear in demanding environments. The wires are bundled securely to keep the setup organized and prevent tangling during operation. Connection points are prepared for wiring directly into your existing pendant enclosure and the main lift control board. Direct Replace Drop-in harness Thick Jacket Friction protection Bundled Tangle-free routing Pre-Termed Ready for hookup Wire Harness Only Pendant housing and push buttons are not included. This product is the wire harness by itself. Designed for operators who need to replace damaged cables while keeping the existing pendant switch housing and internal push buttons intact. Before You Install Confirm terminal placement against your lift manual. Refer to the manual for your specific lift system to confirm proper terminal placement before completing the installation. Restores Pendant-to-Lift Communication The harness provides the wiring pathways needed to transmit directional signals from the manual pendant controller directly to the hydraulic power unit. When a damaged or worn cable is interrupting that signal, this is the replacement that restores normal up/down operation. Thick Protective Outer Jacket The exterior jacket shields the internal conductors from friction, abrasion, and daily wear in demanding lift environments. Built to handle the kinds of repeated bends, drags, and grit exposure that destroy unsheathed cabling. Bundled, Tangle-Free Construction The internal wires are bundled securely to keep the setup organized and prevent tangling during operation. Cleaner routing inside the pendant enclosure, fewer snags during use, and easier service down the line. Pre-Terminated for Direct Hookup Connection points are prepared for wiring directly into your existing pendant enclosure on one end and the main lift control board on the other. No splicing or specialty connectors required, just match the terminals against your lift manual and tighten down. What’s in the Box 1 × Hydraulic Pendant Switch Wire Harness Pendant switch housing and internal push buttons are not included. Reuse your existing control assembly. Questions? Call (260) 918-2758 or email sales@lakelite.com