LAND ROVER DEFENDER 110 TDCI Axle & Transfer Box Breather Kit

Pioneer 4x4Land Rover · Defender 110 Tdci Defender 110 Tdci Axle & Transfer Box Breather Kit Three braided stainless breather lines for the front axle, rear axle and transfer box — routed high to help keep water out when wading. The factory breathers vent through short pipes low down on the axles and transfer box. When a hot component is plunged into cold water, the air inside contracts and can draw water through a low breather. This kit is designed for the Land Rover Defender 110 Tdci. It relocates the front axle, rear axle and transfer box breathers using three stainless-braided lines, helping them draw clean air from a higher, protected position. Build specification Wading Water protection Raises the three supplied breathers to help reduce the risk of water entering during wading. SS Braided hoses Stainless-braided breather hoses stand up to heat, abrasion and under-vehicle grime. 3 Lines One vehicle A vehicle-specific set for the front axle, rear axle and transfer box on a Defender 110 Tdci. The hero feature Why relocate your breathers? Axles and transfer boxes heat up and cool down as you drive. If a hot casing is suddenly immersed in cold water, the air inside contracts. When its breather is low down, it can draw in water along with air. This kit routes the front axle, rear axle and transfer box breathers to a higher, protected position using braided stainless hoses. It is designed to help reduce water ingress, milky oil and premature wear during off-road use and wading. Key features Three breather lines for the front axle, rear axle and transfer box Stainless-braided hoses — tougher than the original plastic pipework Routes the supplied breathers to a high, protected position Helps reduce water ingress and contamination during wading Vehicle-specific kit for the Land Rover Defender 110 Hand-built in Devon alongside our braided brake, clutch and fuel lines Does not include a gearbox breather line What's included A complete three-line kit for your vehicle One stainless-braided breather line for the front axle One stainless-braided breather line for the rear axle One stainless-braided breather line for the transfer box Fittings to route and terminate the three breathers at a high, protected point The Pioneer 4x4 difference Built for deep water Built in-house by Pioneer 4x4 to the same standard as the braided brake and clutch lines we're known for — a durable upgrade over the original breather pipework. Not sure it's the right one for your vehicle? Get in touch and we'll confirm the fit. Pioneer 4x4 — Precision Engineering