ESP32-S3 Motion Kit with 2 MPU6050 Sensors & OLED

Explore acceleration and rotation with an ESP32-S3 motion sensing kit containing two MPU6050 sensors and a 0.96-inch blue SSD1306 I2C OLED. Start with one sensor, then configure different I2C addresses to compare motion at two locations. Your firmware can process sensor data and show experimental readings on the display for robotics, gesture sensing or other embedded projects. The ESP32-S3 DevKitC-1 and sensors have pre-soldered headers, and the kit includes a 400-point breadboard and 10cm jumper set. You supply the wiring, firmware, computer and suitable USB data cable.Bundle value: Purchased separately, the included component variants total $38.61. This kit is $31.99, saving $6.62. 1 × ESP32-S3 DevKitC-1 board with pre-soldered headers 1 × two-pack of pre-soldered MPU6050 motion sensors: 2 sensors total 1 × 0.96-inch blue SSD1306 I2C OLED display 1 × 400-point solderless breadboard 1 × 120-piece, 10cm jumper wire set: male–male, male–female and female–female Assembly and your own firmware are required. Using both sensors on one I2C bus requires different sensor addresses. Connect the controller beside the breadboard with jumper wires. A suitable USB data cable, computer, power source and enclosure are not included.Read the kit setup guide for assembly planning, required extras and component references.