Chicago Pneumatic CPRC 3-100 Workshop Air Compressor (100L)

The Chicago Pneumatic CPRC 3-100 is a 3 HP belt-driven compressor on a 100 litre tank. The larger receiver means the motor cycles far less under sustained use, which is the main practical difference from the 50 litre models. Oil-lubricated240V 15 AmpStandard duty PowerNeeds a 15 Amp outlet, not a standard household point. Check before ordering. WorkloadSuits daily trade use for one operator. The 100L tank means noticeably less cycling than a 50L unit. NoiseLouder than an oil-free unit. Better suited to a workshop than a customer-facing space. Air qualityOil-lubricated. Fit a filter and water separator before any tool used near paint or interiors. Best suited to Ideal for Single-bay detailing studios Workshops running air tools daily Setups where a 50L tank cycles too often Trade and light commercial use Not the right choice if You only have a 10 Amp power point You need a quiet compressor for customer-facing spaces You are running three or more tools at once What it can handle Application Suitability Blow gun / drying Comfortable Interior cleaning gun Comfortable, the 100L reserve absorbs demand well Tyre inflation Comfortable Air sander or polisher Suitable for single-operator use Two tools at once Possible for low-draw combinations, not recommended routinely Tool and application suitability above is general guidance based on typical air consumption, not a performance guarantee. Actual results depend on your tools, air line setup, working pressure and how continuously you run them. If you are unsure whether this compressor suits your specific setup, get in touch before ordering. Before you order: Requires a 15 Amp outlet, not a standard 10 Amp household point. Check your power supply before ordering. Specifications Specification Detail Motor 3 HP / 2.2 kW Pump displacement 13.5 CFM / 380 L/minThis is what the pump moves. Usable output at the tool is lower. Maximum pressure 10 bar / 145 psi Tank 100 litresDouble the reserve of a 50L unit, so fewer start-stop cycles. Power supply 240V single phase, 15 AmpNot a standard household outlet. Pump type Piston, oil-lubricated, belt-driven, dual cylinder Weight 93 kg Dimensions (L x W x H) 940 x 430 x 1010 mm Choosing the right option Choose this if you have a 15 Amp supply and want a solid single-bay workshop compressor at a sensible price. Step up if noise matters. The CPRS 3-270 is far quieter with a much larger reserve. Step down if you only have 10 Amp available. The CPRC 2.5-50 runs on a standard outlet. Common questions Can I plug this into a normal power point?No. It requires a 15 Amp circuit, which uses a larger plug than a standard 10 Amp outlet. Confirm this before ordering.Is 100 litres enough for daily detailing work?For a single operator, yes. The larger reserve means noticeably less cycling than a 50L unit during sustained work.Do I need a filter for detailing work?Yes. Fit a filter and water separator before any tool used near paint, coatings or interior surfaces.What maintenance does it need?Periodic oil changes and regular tank draining. Contact us for recommended service intervals. Planning a full compressed air setup? Plan Your Air Line Compare All Compressors