PCAN Repeater FD with 5 kV Isolation

CAN CC and CAN FD repeater for decoupling bus segments The PCAN-Repeater connects two CAN bus segments with up to 5 kV galvanic isolation, supporting both CAN CC and CAN FD at bit rates from 14 kbit/s to 8 Mbit/s. Its DIN rail housing and extended temperature range make it well-suited for industrial deployments. No configuration is required The repeater forwards all CAN messages and error frames 1:1 between ports, improving signal quality while remaining fully transparent to the bus, just like a length of cable. It's ideal for isolating two CAN segments or extending stub lines to support additional CAN nodes. Note: Because CAN bus length is bit-rate dependent, the PCAN-Repeater cannot be used to extend total bus length. Each unit installed reduces the network's maximum physical length by an amount corresponding to its transit delay. Pin Assignments Both CAN ports are located on the front of the housing. Package contents PCAN-Repeater (IPEH-004039) in DIN rail plastic casing 2 mating connectors 4-pin for CAN connections (Phoenix Contact: FKC 2,5/ 4-ST GY - 1756260) 1 mating connector 3-pin for power supply connection (Phoenix Contact: FKC 2,5/ 3-ST GY - 1857772) Manual in PDF format Printed quick start guide