Hammer Side Table

Two shapes. One texture. Limited to only 50 numbered editions, the Hammer Side Table is a square on a cylinder—as simple as a form gets—until the hand gets to work. Its surface came out of months of carving studies in the studio: test block after test block, chasing the cut that would give a flat, beautiful piece of walnut a skin. Hundreds of gouge marks, each one a decision. Simplicity with definition. Texture that earns its place. EDITION & INSPIRATION– Only 50 numbered editions worldwide– Born from a series of carving studies—the method was found by hand, in walnut, before the table was drawn DESIGN & PURPOSE– A side table for beside a chair, a bed or a bath—small enough to live anywhere– A study in restraint: the form stays quiet so the surface can speak– Made to be touched—the base invites the hand the way the top invites a glass SIGNATURE DETAILS– Cylindrical base hand-carved with a gouge, every facet cut individually, no two alike– Square top with a deep, clean edge—smooth where the base is rough– The carved texture steps up onto the top's end grain, so the two halves share one language AVAILABLE SIZE W400 D400 H450 mm Custom sizes available on request. MATERIALS & FINISHES– Walnut: rich, warm grain (shown)– American Oak: light, textural beauty– Black American Oak: bold, graphic contrast– Custom finishes available on request NOTES– Handcrafted on the South Coast, New South Wales– Lead time: 8–10 weeks– Fully customisable—materials, finish & dimensions– Handmade variations expected; surface irregularities and traces of fabrication are inherent to the piece– Freight calculated by location (local pickup available South Coast, NSW)