Melopero CM5 Touch Connect

The carrier board designed for the Raspberry Pi Touch Display 2 and Raspberry Pi Compute Module 5. Melopero CM5 Touch Connect is a compact carrier board specifically engineered to be mounted directly behind the Raspberry Pi Touch Display 2. Combining the Compute Module 5 (CM5) with the official display into a seamless ‘All-in-One’ system, this board offers a clean, professional solution for industrial HMI, smart home hubs, and edge computing. Power & Programming: The USB-C port serves as both the power input and the interface for CM5 EEPROM programming when used with the onboard tactile button. RTC Battery: Fully compatible with the official Raspberry Pi RTC battery. The CM5 can be configured to recharge the battery while the system is powered. GPIO Freedom: By using the dedicated display power header instead of the 40-pin GPIO, you ensure maximum compatibility with existing Raspberry Pi HATs. Specifications Compatibility Supports all Raspberry Pi Compute Module 5 (CM5) variants Video & Touch 1x HDMI, 2x MIPI (CSI/DSI 22-pin), Dedicated display power header Networking Gigabit Ethernet (10/100/1000) with PoE HAT support header USB Ports 2x USB 3.0 Type-A Power & Programming 1x USB-C (Power & EEPROM programming via dedicated Tactile Button) Expansion Standard 40-pin GPIO (2×20), Qwiic I2C connector Management On-Off Power Button, 4-pin FAN connector, Status LEDs (Red/Green) Utility Official RPi RTC Battery connector (supports charging if enabled via CM5) Configuration Jumper selector for I2C routing on MIPI1 What’s in the box 1x Melopero CM5 Touch Connect carrier board 1x 200mm Display Cable (official Raspberry Pi compatible) 2x Jumper Caps (2.54mm pitch) to enable I2C routing on the MIPI 1 connector (Note: Raspberry Pi Compute Module 5 and Touch Display 2 are not included)