ASI - 9343 Profile™ Liquid Soap Dispenser – Surface Mounted

ASI - 9343 Profile™ Liquid Soap Dispenser – Surface Mounted Satin finish stainless steel liquid soap dispenser has a capacity of 48 fl. oz. (1.4 L). Includes a tamper-resistant refill window with concealed fastening and vandal-resistant hinged filler-top. Stainless Steel Construction Our heavy-duty items are made of high-quality 304 stainless steel, which is tough, durable, stain-resistant and easy to clean. Features Satin finish stainless steel construction Type 304 stainless steel Robust 16 gauge stainless steel face Curved radius edges Surface mounted 48 fl. oz. (1.4 L) capacity All-purpose valve dispenses liquid, lotion and detergent-type soaps Tamper-resistant refill window with concealed fastening Vandal-resistant hinged filler-top 3/16″ concealed piano hinge adds durability Specifications Model 9343 Series Profile™ Type Liquid Soap Dispenser – Surface Mounted Dimensions 7-1/4” x 6-1/2” x 3-11/16” (184 x 165 x 94 mm) Spout Projection 15/16” (24 mm) Capacity 48 fl. oz. (1.4 L) Construction Type 304 Stainless Steel Mounting Surface Mounted Dispensing Manual push-button operation Soap Requirements Soap Requirements Proper usage of this dispenser requires, that only soap within the following range for viscosity and pH may be used. Viscosity Range (mPa·s or cP) 100 – 2.5k pH Range 5.5 ~ 8.0 Consumable Type Liquid Soap Finishes Satin Finish Operation & Maintenance Soap is manually dispensed by depressing the push button. Unit is refilled through the hinged door at the top requiring the special key supplied to open. Soap tank will continue to feed properly until empty. Tank supply is replenished manually according to maintenance needs. Under normal usage, stainless steel products require regular cleaning with a soft clean rag moistened with a mild detergent, followed by a water-moistened clean rag and then a dry rag. Soap dispenser valves in low-traffic areas should be wiped regularly to remove air-hardened soap residue from the nozzle spout. If the dispenser fails to operate because of dried soap or debris, the dispenser may be removed from the wall plate and flushed with hot water as described in the ASI installation and maintenance instructions. Installation Unit is surface mounted to wall or partition by means of a wall mounting plate and screws. Unit is secured to the mounting plate and locked in place by means of a locking screw installed through the tamper-resistant refill door. Recommended mounting height for general utility is 42″ (1067 mm) Above Finished Floor (AFF) or 6″ (152 mm) minimum above the wash basin to bottom of unit. Allow 4″ (102 mm) minimum clearance above the unit for filling. Mount wall plate vertically with the wide part of the “V” at the top. Use suitable mounting hardware for the wall construction. Unlock the filler door using the special service key furnished, position the dispenser on the wall plate, press the tank down firmly, and tighten the internal locking screw securely. For maximum usability and ADA accessibility, the valve may be installed at a maximum of 54″ (1372 mm) AFF for clear-floor side reach, 48″ (1219 mm) AFF for clear-floor forward reach, or 46″ (1168 mm) AFF where side reach over an obstruction is provided. Downloads Product Care & Maintenance Soap & Hand Sanitizer Dispensing Chart Installation & Maintenance Instructions – 9343 Technical Data Sheet – 9343