Rear Loadspace LED Roof Light for Land Rover Defender L663

Finding gear in the Land Rover Defender cargo area at night is difficult because the single factory side courtesy light is positioned low and easily blocked by luggage. This leaves the main loadspace and tailgate work area in deep shadow. This rear loadspace LED roof light replaces the blank factory plastic trim above the rear door, casting balanced downward illumination across the entire cargo floor and tailgate opening for camping, trail maintenance, and nighttime loading. WHY THIS UPGRADE MATTERS Full Cargo Illumination: Floods the rear cargo floor and tailgate work area with balanced downward light from dual frosted 6000K LED modules. Flush Factory Integration: Clips directly into the rear roof header opening to replace the blank trim panel without panel gaps or dashboard trimming. Direct Inline Wiring: Connects directly into the factory courtesy light circuit using a dedicated Y-split adapter harness without wire cutting. Tailgate Circuit Sync: Turns on automatically when the tailgate opens and shuts off upon closure, syncing with vehicle sleep cycles. Specifications Material: Automotive-grade ABS housing with frosted polycarbonate lenses Light Source: Dual SMD LED modules (6000K crisp white) Voltage: 12V DC via factory courtesy circuit Mounting: Direct snap-in replacement to factory roof aperture Wiring: Dedicated plug-and-play inline Y-split harness Compatibility: Land Rover Defender 90, 110, and 130 L663 (2020-2025) Installation & Compatibility Notes Installation uses a non-marring pry tool to remove the factory cargo side light and the blank upper roof trim. The included Y-split harness connects inline with the factory courtesy lamp plug before the new light panel snaps directly into the upper roof aperture. Fits 2020 to 2025 Defender 90, 110, and 130 models with standard rear roof trim. Install Difficulty: 1/5 (DIY Friendly) Estimated Install Time: 15-20 minutes What is Included 1x Rear Loadspace LED Roof Light Panel Assembly 1x Dedicated Plug-and-Play Y-Split Wiring Harness Product FAQ Q: Which Defender body styles are compatible with this roof light? This light panel fits Land Rover Defender 90, 110, and 130 L663 models across model years 2020 to 2025 sharing the standard rear roof header trim opening. Q: Does installation require cutting or splicing factory wires? Wiring connects inline using the supplied Y-split adapter harness that plugs directly into the factory side courtesy lamp connector without cutting or splicing. Q: What should I check if the light does not turn on immediately after installation? The Defender body control module enters sleep mode if the tailgate stays open during installation. Cycle the tailgate latch or press the key fob unlock button to restore circuit power.