LED Lightsheet Power Lead | Solderless Clip Connector | 14AWG | 20A | Single-Ended Power Supply Connection

LED Lightsheet Power Lead – The Feed From Your Driver Into the Sign A run of LED Lightsheets needs one power feed from the driver. This is it. One clip-on connector at the panel end, two bare tinned wire tails at the driver end, ready to drop into your 24V power supply terminals. Here's how it works: The white connector body clips directly onto the contact pads at the edge of a Lightsheet, no soldering and no separate terminals. The opposite ends are stripped and pre-tinned, so they push straight into your driver's output terminal block and clamp down clean. From that first powered sheet, Jumper Cables carry the supply across to the rest. Why it matters: A bad power feed is the most common reason a sign runs warm at the supply corner, dims down the chain, or fails early. A solderless clip with correctly sized conductor gives you a solid, repeatable joint, without a soldering iron near a thin acrylic panel and without guesswork on the bench. Key Advantages: Solderless clip-on fitting – Connects to the Lightsheet contact pads by hand in seconds. No iron, no flux, no risk of heat-damaging the panel. 14AWG conductor – Properly sized copper for full-run Lightsheet current, so the feed is not the weak point in the install. Pre-tinned bare tails – Driver-side ends stripped and tinned ready to terminate. Straight into the terminal block, no fraying. One feed for up to 10 sheets – A single Power Lead supplies a full chain of up to 10 panels linked with Jumper Cables. No need for a separate run to each sheet. Polarity marked – Clear positive and negative on the connector body so you wire it the right way round without tracing cores. Perfect Applications: Single-panel sign – One Power Lead from the driver to the sheet and the panel is live. Multi-panel run up to 10 sheets – The Power Lead feeds the first sheet; Jumper Cables carry power across the rest. One driver, one feed, one tidy install. Also ideal for illuminated signage, lightboxes, retail display panels, exhibition graphics, and any 24V Lightsheet install needing a clean solderless power feed. Browse our LED Lightsheets and LED Drivers, or contact our technical team for free consultation: sales@weloveleds.co.uk