GE DS200DTBCG1A Connector Relay Terminal Board

The GE DS200DTBCG1A, also cataloged as the DS200DTBCG1A Connector Relay Terminal Board, operates as a dedicated hardware component for discrete signal interfacing and relay contact switching within Mark V control system platforms. Suffix Breakdown & Model Matrix DS200: Identifies the Mark V series hardware. DTBC: Designates the Connector Relay Terminal Board architecture. G1: Represents the hardware group/generation tier. A: Indicates the initial revision level. REV AA: Specifies the manufacturing design version. Hardware Specifications Parameter Specification Model DS200DTBCG1A Brand General Electric Origin USA Weight 0.55 kg Dimensions 33.0 x 17.8 x 3.0 cm Operating Temp 0 to 60 deg C Power Consumption Passive relay load Board Type Relay Terminal Board Profinet / EtherNet/IP deterministic networks The DS200DTBCG1A serves as the primary transition point for high-density I/O signals, providing the necessary relay isolation required for discrete field device operation. The board facilitates the conversion of low-voltage processor signals into high-capacity switching paths suitable for valve actuation and status alarming. By integrating dedicated relay sets, the board ensures the physical separation of field voltage levels from the control rack circuitry, mitigating the risk of noise induction and transient voltage damage to the main I/O processors during switching cycles. Frequently Asked Questions Q: Can this terminal board be used in applications requiring high-frequency relay cycling? A: The mechanical relays installed on this board are rated for standard industrial control intervals. If the application requires high-frequency switching, verify the relay contact life specifications in the system documentation to prevent premature failure. Q: Are there specific grounding requirements for the DS200DTBCG1A? A: Yes. The board must be securely fastened to the cabinet chassis to maintain a common ground plane for the relay return paths. Failure to ensure proper chassis grounding may result in degraded relay performance or signal crosstalk. Field Installation Guidelines Confirm that all control rack power is disconnected and locked out prior to handling the terminal board. Align the PCB with the designated mounting standoffs in the rack, ensuring sufficient clearance for cable management. Torque the mounting screws to the specified value to establish a reliable chassis ground connection. Interface the field wiring to the terminal blocks, ensuring that all conductors are routed according to the terminal mapping provided in the system wiring diagrams. Verify that all cable connectors are fully seated and that any associated jumper settings match the desired operational logic for the specific control loop.