SP 10MM NEO NEW 2026 - MIDRANGE EXTREME 10"/25CM NEO MAGNET 300W RMS (UNIT PRICE)

SUPER POWER AUDIO DESIGNED IN ITALY MMXXVI midrange extreme · neodymium · 10 inch · new 2026 300 watt RMS. Ten inches, no ballast. The 2026 neodymium 10"/25 cm of the EXTREME line: 99.6 dB, a 60.5 mm (2.5") CCAW voice coil and a solid aluminium phase plug. Same power as the ferrite SP 10MM, in a motor that is much smaller and lighter — four of them weigh like two. Unit price. 300WRMS · 4 Ω 600WMAX · PEAK 99.6dBSPL 1W/1M 🔒 Secure checkout · SSL & PCI DSS↩ 14 days to change your mind (EU)✓ Invoice from an Italian company✓ Data from the 2026 factory manual ✓ ITALIAN DESIGN✓ 4 OHM✓ UNIT PRICE✓ FREE SUPPORT✓ NEODYMIUM MOTOR 01 Power, measured not promised RMS · 4 Ω 300 W MAX · PEAK 600 W PER SPEAKER · RMS IS CONTINUOUS POWER, NOT BURST · NOMINAL 4 Ω 02 Why this midrange 99.6 dB: the loud lane Almost 100 dB from one watt. On a 300 W channel this is competition-level output from a single 10" cone. Neodymium: force without bulk The same magnetic force as a heavy ferrite ring in a much smaller and lighter motor. Bl of 10.5 TM — more motor than the ferrite version, with a fraction of the weight. A 2.5" coil for 300 W of duty 60.5 mm of CCAW voice coil: more winding surface, more heat capacity, more minutes at full volume. A curvilinear cone Curvilinear fiberglass reinforced paper: the curved profile spreads break-up, so the midrange stays clean when you push it. “Continuous RMS only. No peak, no burst, no marketing watts.” 03 Look at it closely 01 · the coneCurvilinear fiberglass reinforced paper, M-ROLL polycotton surround, solid aluminium phase plug in the centre. 02 · the motorCompact neodymium magnet, 60.5 mm CCAW voice coil, copper-clad aluminium wire. Free shippingDispatched from Italy in 24–48 working hoursWarranty on manufacturing defectsFree technical support from Italy FACTORY MANUAL & SPECIFICATION SHEET Full specifications, Thiele-Small parameters and mounting data, straight from the 2026 factory sheet. ⇩ Open the manual (PDF) English · 2026 edition · opens in a new tab 04 What you receive One speaker, sold singly. The price on this page is for one SP 10MM NEO. SPL builds use them in twos and fours: order the number your project needs, they ship from the same production batch. Packed in the SP Audio box with the protective foam. In the box: 1 × SP 10MM NEO midrange · mounting screws · SP Audio packaging. Not included: grilles, speaker cable, crossovers and adapter rings — installation materials, chosen for your car. 05 Technical specifications POWER & LOAD Rated power (RMS) 300 W Peak power (MAX) 600 W Rated impedance 4 ohm ACOUSTIC Nominal diameter 250 mm (10") Sensitivity 99.6 dB SPL 1W/1M Frequency range 50 Hz - 6 kHz MOTOR & MATERIALS Voice coil diameter 60.5 mm / 2.5" CCAW Winding material Copper clad aluminium wire (CCAW) Magnet Neodymium Phase plug Aluminium, solid Suspension M-ROLL, polycotton Cone Curvilinear, fiberglass reinforced paper Sold as Unit (1 piece) THIELE-SMALL PARAMETERS Fs 113 Hz Re 3.2 ohm Qts 0.430 Qes 0.460 Qms 6.546 Vas 21.083 L Xmax 2.5 mm Sd 353 cm² Cms 123.642 µm/N Mms 30.538 g Bl 10.453 TM η0 2.431 % MANUFACTURER’S LABORATORY DATA · PEAK OR “BURST” FIGURES USED IN SOME MARKETS ARE NOT RMS AND ARE NOT LISTED 06 Complete the system SAME POWER, FERRITESP 10MM — 300 W RMSNEODYMIUM 8"SP 8MM NEO — 250 W RMSTHE STEP UP, 10"SP 10MM PLUS — 400 W RMS4 CHANNEL AMPLIFIERSP-300.4 MINI 07 Before you install it Do not go below 4 ohm per channel. Two speakers in parallel on one channel give 2 ohm: most amplifiers will heat up or go into protection. Use a high-pass filter. This is a midrange, not a subwoofer: it reaches 50 Hz, but for SPL duty cut higher and let the subwoofer do the bass. Set the gain properly. Clipping kills voice coils far more often than power does. Plan the mounting. A 10"/25 cm frame does not fit factory door holes: it wants a door pod, a kick panel or a custom baffle, solidly fixed. It runs to 6 kHz: always pair it with a tweeter. 08 Questions installers ask How much power does the SP 10MM NEO handle?300 W RMS continuous and 600 W peak. The price on this page is for one speaker. What amplifier does it need?4 ohm nominal: an amplifier able to deliver about 300 W RMS at 4 ohm on the channel that drives it. Is the price for one unit or for a pair?For one speaker. Order the number your build needs — they ship matched from the same batch. What is the difference with the SP 10MM?Same 10" cone, the same 2.5" CCAW voice coil and the same 300 W RMS. The NEO uses a neodymium magnet: same power in a much smaller and lighter motor. What is the cone made of?Curvilinear fiberglass reinforced paper: light and rigid, so it keeps its shape at high volume. Free technical support from Italy. Write or call and a person answers, with the real data of the product sheets. Tell us what you want to build — power, crossover points, door or kick panel — and we will help you match it. spaudio@spaudio.it · +39 340 807 8778 Accepted payment methods Visa · Mastercard · Maestro · American Express · PayPal · Apple Pay · Google Pay · Shop Pay · Klarna SP Audio — Super Power Audio. Designed in Italy by Audiocar Import & Export SRLS, Milano, official SP Audio distributor for Europe.