Razor & Brush Stand Plates in Multiple Sizes

These replacement brush plates are designed for our stainless steel razor and brush stand, though will work with most other stands. These plates allow you to hang a variety of different sized brushes on stands similar to the one in the picture below. Designed for our stainless steel stands, they will fit most stands of this type. Each plate is made from 304 stainless steel and is sold individually. Choose the plate size that best fits where you prefer your brush to rest, whether that is near the handle or closer to the knot. Available sizes: 24 mm 27 mm 31 mm 34 mm 37 mm 40 mm 43 mm To select the right size, measure the area of the brush where it will sit in the plate. Add about 1 mm, then choose the next largest plate size. The fit does not need to be exact, but choosing the next size up usually gives the brush a more natural rest. Please note: This listing is for the brush plate only. Stand, razor, and brush are sold separately. Compatibility With Other Stands Want to use these plates with a non-Hendrix Classics stand? In many cases, you can. These plates are designed for our stainless steel razor and brush stand, but they may also fit other stands that use a threaded center post. To check compatibility, measure the hole in the center of your current plate or the threaded post on your stand. For the plate to fit properly, the center hole must be: 5 mm or larger for the 43 mm. 6 mm or larger for the 24 mm, 27 mm 31 mm, 34 mm, 37 mm, and 40 mm. Please note that we cannot guarantee fitment with every non-Hendrix Classics stand, since post sizes and threading can vary between manufacturers. However, if your stand’s threaded post fits through the center hole size listed above, these plates should work. Details Replacement/additional brush plate for our stainless steel razor & brush stand Allows the stand to fit a wider range of brush sizes Made from 304 stainless steel Available in multiple sizes Sold individually Stand, razor, and brush not included