2021+ Gen 3 Raptor Fabricated Coil Bucket Replacement Kit

FACTORY vs. FABRICATED This Fabricated Coil Bucket Kit replaces the OEM stamped-steel coil bucket with a reinforced boxed steel design built for extreme-duty use on 2021+ Ford Raptor / Gen 3 Raptor applications. CAUSE OF STOCK FAILURE The factory coil bucket on the 2021-2026 Ford Raptor is a thin stamped steel component designed for OEM suspension loads. Under aggressive off-road use, larger tires, long-travel suspension systems, and repeated high-impact driving, it can develop cracks, fatigue, and deformation over time. UPGRADED SOLUTION Engineered for serious Gen 3 Raptor builds where OEM limitations are no longer enough. This fabricated coil bucket provides a reinforced, high-strength foundation for long-travel suspension systems, higher spring rates, and extreme off-road conditions. THIS KIT IS DESIGNED TO: • Replace the thin stamped OEM coil bucket structure with a fully fabricated, high-strength design • Spread load across a boxed, reinforced architecture to reduce stress concentration points • Support longer-travel shocks, higher spring rates, and repeated hard bottom-outs • Reduce the risk of cracking and fatigue in high-performance off-road builds • Improve durability under aggressive desert and high-speed off-road conditions FABRICATED COIL BUCKET STRUCTURE: • Full OEM coil bucket replacement designed for increased strength and durability • Engineered for high-load suspension systems and aggressive off-road use • Reinforced geometry to better handle repeated impact and compression cycles FEATURES - REINFORCEMENT RING PLATES • Designed to spread the load of the shocks to prevent the front strut tower from cracking and will help strengthen the shock bucket • Precision laser cut in-house from 3/16" thick steel • Bolt-on support rings for easy installation with no modifications required • Uses factory hardware for a clean, direct-fit installation FEATURES - VERTICLE CORNER GUSSET PLATES • Includes corner gusset plates for added structural reinforcement • Strategically designed to strengthen high-stress junction points • Helps distribute load and reduce flex in extreme driving conditions INSTALLATION NOTICE PLEASE READ BEFORE ORDERING : • This kit MUST be installed by a qualified fabricator • Welding and structural modification to the factory frame is required • Proper alignment and suspension setup after installation is recomended