Enviro-Pro Environmental Controller by Digi-Lumen — Temp, Humidity, CO₂ & VPD with 4-Channel Dimming
The Digi-Lumen Enviro-Pro is an all-in-one environmental controller that runs your whole room from a single 5-inch touchscreen. It reads temperature, humidity, CO₂, VPD and light in real time through the included 4-in-1 sensor, then coordinates heating, cooling, humidity, CO₂ and up to four lighting zones to hold your targets steady. Ethernet and app control add remote monitoring and alarms, so you can dial in a tent or a small commercial room and leave it to run. Real-Time 4-in-1 Monitoring The included BLS-4 sensor reads temperature, humidity, CO₂ and light. VPD, EC, pH and water temperature are covered too, with optional add-on modules. 4-Channel 0–10V Dimming Control up to four lighting zones independently in Manual, Auto Timer or Auto Cycle mode — plus PAR-based auto-dimming when a PAR sensor is connected. 4-Port Device Automation Assign each 240V port to heating, cooling, humidify, dehumidify or CO₂. Sunrise/sunset scheduling, fuzzy-logic CO₂ and smart locks keep it stable. Touchscreen + App Control A 5-inch 800×480 display makes setup clear, and the built-in Ethernet port binds to the Digi-Lumen app for remote monitoring, control and alarms. Specifications Display 5" LCD, 800 × 480 Monitors Temp, humidity, CO₂, VPD, light (EC/pH/water temp with modules) Light Control 4 × 0–10V (30mA per channel) Device Ports 4 × 240V (8A per port) Operating Voltage AC 100–240V, 50/60Hz Max Input Current 10A Sensor Port RJ12 (RS485, 12V / 0.5A) Network RJ45 Ethernet (DHCP or manual IP) Communication RS485 (9600 baud, 8N1) Operating Temp 0–50°C Protection IP20 (indoor use) In the Box Enviro-Pro, BLS-4 sensor, 5m RJ12 cable, splitter, mount kit Getting accurate control Mount the 4-in-1 sensor at canopy height and keep it out of direct light from the fixtures — direct light skews the temperature and photocell readings. Set your targets by VPD rather than humidity alone, and let the controller coordinate humidify and dehumidify to hold the zone steady. Use the smart locks (cooling and dehumidify, CO₂ and cooling, CO₂ and dehumidify) so devices do not fight each other and waste power. CO₂ dosing pauses automatically in the dark, so there is no need to schedule around lights-off. Getting Set Up 1 Mount the controller with the wall screws, or the U-bolt on your tent frame. 2 Connect the BLS-4 4-in-1 sensor via the 5m RJ12 cable, placing it at canopy height and out of direct light. 3 Assign each of the four 240V ports to a device — heater, cooler, humidifier, dehumidifier, or CO₂ gear. 4 Wire your 0–10V lights to the four dimming channels and choose Manual, Auto Timer, or Auto Cycle. 5 Bind the controller to the Digi-Lumen app by QR code over Ethernet for remote monitoring and alarms. Pairs Well With The Digi-Lumen Range The Enviro-Pro dims the whole Digi-Lumen Extreme LED range over 0–10V — pair it with the fixtures it was built to run. Environmental Monitors Add standalone monitors to cross-check readings or watch a second zone alongside the controller. Grow Lighting Any 0–10V dimmable fixture wires into the four channels — browse the full lighting range to fill your zones. FAQ What does it monitor? Temperature, humidity, CO₂, VPD and light out of the box via the 4-in-1 sensor, plus EC, pH and water temperature with the optional ECPH module. How many devices can it control? Four 240V device ports — heat, cool, humidify, dehumidify, or CO₂ up/down — plus four independent 0–10V lighting channels. Can I control it remotely? Yes. It has a built-in Ethernet port and binds to the Digi-Lumen mobile app by QR code for remote monitoring and control. Does it work with non-Digi-Lumen lights? Yes. The four dimming channels use standard 0–10V, so any 0–10V dimmable fixture will work. Is it waterproof? No. It is IP20, rated for indoor use only — keep it dry and mounted away from direct water contact. Total Control of Your Grow Environment Temperature, humidity, CO₂, VPD and lighting from one touchscreen. Free shipping over $499*. Add to Cart View the Digi-Lumen Range
Variants (1)
- Default Title — 999.95 AUD — In stock
AI Readiness
Good foundation, but some important product data is still missing.