Flywoo GOKU F405 HD 1S 5A ELRS AIO V2.0

Flywoo GOKU F405 HD 1S 5A ELRS AIO V2.0 A 2.6 g 1S all-in-one flight controller for ultra-micro HD FPV builds, combining an STM32F405 MCU, onboard ELRS 2.4 GHz, a 4-in-1 5A ESC and support for DJI O4, Walksnail and HDZero systems. 2.6 g Stated board weight 5A / 8A Continuous / peak ESC current 5V 3A max Onboard BEC 8 MB Betaflight blackbox flash Designed for ultra-micro 1S HD builds Flywoo's cross-shaped V2 board is specified for 1S HD drone setups using DJI O4, Walksnail or HDZero. The onboard Flywoo O4 1S 5V BEC supports a stated minimum operating voltage of 2.6V when paired with a DJI O4 VTX. The board measures 30.5 × 30.5 mm and uses a standard 25.5 × 25.5 mm square mounting pattern measured to the centre of the holes. Integrated control and receiver hardware STM32F405BGA MCU The STM32F405 BGA processor is listed at 168 MHz for the flight-control workload. ELRS 2.4 GHz with TCXO An integrated serial ELRS 2.4 GHz receiver and temperature-compensated crystal oscillator provide the onboard radio link. ICM42688P and blackbox The board includes an ICM42688P gyro and 8 MB of Betaflight blackbox flash for flight-data recording. Onboard 4-in-1 ESC Power input 1S only Current 5A continuous, 8A peak Digital protocols DShot300 and DShot600 Connectors JST1.25 motor, A30 battery Flight controller specifications Specification Details Product name GOKU F405 HD 1S 5A AIO V2.0 with TCXO ELRS MCU STM32F405BGA, 168 MHz IMU ICM42688P Barometer SPL06 Blackbox 8 MB OSD support No Protocols CRSF, SBUS, iBus, Spektrum BEC 5V 3.0A maximum; supports DJI O4 Air Unit Receiver Flywoo TCXO EL24E 2400 RX 3.0.0 FC firmware FLYWOOF405S_AIO Dimensions 30.5 × 30.5 mm Mounting holes 25.5 × 25.5 mm square to centre of holes Weight 2.6 g stated product weight ESC specifications Specification Details Power input 1S only Current 5A continuous, 8A peak ESC firmware O_H_5_48KHz_V0.19.hex Bluejay firmware Digital signal protocol DShot300, DShot600 Motor connector JST1.25 Battery connector A30 In the box 1 × GOKU F405 HD 1S 5A ELRS AIO V2 with pre-soldered motor connectors 1 × Flywoo ELRS 2.4G Minimortal PCB T antenna, UFL, 40 mm 5 × M2 × 6.6 shock-absorbing balls 1 × shrink film 4 × silicone wires, red/black 1 × A30 power cable Compare related 1S AIO options These are alternative products and categories available from Buzz FPV; they are not included with this Flywoo board. T-Motor F411 1S 13A AIO Flight Controller — 25.5 × 25.5 mm T-Motor F411 1S 6A Bluejay AIO with onboard ELRS and analogue VTX Browse 25 × 25 whoop AIO products