Teak x 6oh5oh 3D Printed Fingerboard Deck - Teal

This is a 3D printed deck that doesn't ride like one. Every ply is printed cross-grain and then molded to shape, so the concave, the high kicks, and the pop feel like a real wood board. The graphic is printed into the deck instead of stuck on top, and the plies stack into a teal, purple, and yellow stripe down the edge. It runs a popsicle shape with medium concave and high kicks, responsive enough for street and park. Each one is printed by 6oh5oh in small batches and built to ride daily. Details Each ply printed to provide cross grains like a real wooden fingerboard, then molded to shape after printing Popsicle shape with medium concave and high kicks Sizes (approximate): Thin ~32mm, Medium ~34mm, Wide ~36mm. Length 97mm, wheelbase 58mm Printed in PLA (polylactic acid), a thermoplastic derived from renewable sources Standard truck mounting hole pattern, compatible with most fingerboard trucks and setups Custom design by Mark Howlett (6oh5oh), produced in small batches Includes 1mm foam grip tape Deck only (trucks and wheels sold separately) Note: Due to the 3D printing process, slight variations in finish may occur between decks. Disclaimer: 3D printed materials may be sensitive to heat. Avoid prolonged exposure to direct sunlight, enclosed hot environments, or other heat sources, as this may cause warping or deformation. Warning: Choking hazard, small parts. Not for children under 3 years.