Power Cable – Pixhawk Cube, ArduPilot/PX4 Compatible – JST GH to Molex CLIK-Mate

This dedicated 6-pin power cable is designed to deliver clean, reliable power to the Pixhawk Cube from an aeroPAX6 carrier board or any compatible 6-pin JST GH power module. It features a sleeved construction for durability and a dual-connector format tailored for ArduPilot and PX4-based systems. Key Features Compatibility: Supports Pixhawk Cube (Standard and Orange series) Interfaces with aeroPAX6 carrier board or other 6-pin JST GH power modules Compatible with ArduPilot and PX4 flight stacks Cable Protection: Fully sleeved for abrasion resistance Designed to withstand tight bends, routing through frames, and edge contact Suitable for UAVs, robotics, and embedded platforms Connectors: JST GH 6-pin (1.25 mm pitch) — connects to power module Molex CLIK-Mate 6-pin — plugs into Pixhawk Cube base Electrical: Power and signal lines as per standard Cube power port specification 22 AWG wire gauge for robust current handling in short power runs Applications Powering the Pixhawk Cube from custom or OEM carrier boards Replacing standard cables in tight airframes or protected harnessing Integrating Cube autopilots into drones, AGVs, or industrial systems Clean and reliable power connection in ArduPilot/PX4 systems Technical Specifications Parameter Value Cable Type 6-conductor, sleeved Length 10 cm Wire Gauge 22 AWG Connector A JST GH 6-pin (1.25 mm pitch) Connector B Molex CLIK-Mate 6-pin Use Case Power input from power module to Cube If you require a custom cable length, connector variant, or breakout version, contact us for tailored builds.