Regulator - 5/8ths 3k(psi)

Pull pub-quality pints from a full-size CO2 tank with steady, foam-free pressure. This single-tank regulator is built for serious draft setups — homebrewers running multi-keg kegerators, mobile draft trailers, or anyone scaling up from disposable cartridges to a refillable 5 lb or 10 lb CO2 tank.Why this regulator Built for refillable tanks: Standard 5/8" CGA-320 inlet thread connects directly to most US-spec aluminum and steel CO2 tanks. Dialed-in low-pressure control: Tuned for the 5–15 PSI working range that draft beer, cold brew, and carbonated cocktails actually need. Long-haul durability: Brass body and diaphragm rated for 3,000 PSI inlet — the same hardware pros use behind the bar. Specifications Inlet thread CGA-320 (5/8") Max inlet pressure 3,000 PSI Output range 0–60 PSI (single gauge) Body Brass Compatible with Any standard US CO2 tank (5 lb, 10 lb, 20 lb) How to Install Confirm the tank valve is fully closed. Hand-thread the regulator onto the CGA-320 fitting; finish with a wrench (do not over-torque — the seal is in the nylon washer). Open the tank valve slowly and check the gauge. Adjust the output knob until you hit your target serving pressure (5–9 PSI for most beer styles). Frequently Asked QuestionsWill this fit a paintball CO2 tank?Yes — paintball tanks use the same CGA-320 thread.What PSI should I run for beer?Most ales and lagers serve cleanly between 5–9 PSI at refrigerator temperature. Stouts and nitro pours run differently — see our Nitrogen Mini Keg System for those.Can I use this with a mini keg cartridge?No — this regulator is for full-size refillable tanks. For 16g and 74g threaded cartridges, use the regulator that comes with our Premium Draft Mini Keg System.Pairs Well WithStep up to a full-size setup with our Premium Draft CO2 Party Keg System, or grab a CGA-320 CO2 Tank Adapter if you're connecting a non-standard tank.