100mm ODE STARflex Acoustic Partition Roll HP 6.5m x 1.2m - 7.80m2 per roll

At 130mm finished wall thickness, a partition built with 100mm ODE STARflex Acoustic Partition Roll HP is the best-performing build-up ODE publishes for this range: a 100mm profile, 100mm of STARflex APR and 15mm plasterboard on both faces, quoted at 45.1dB. That is the case for going to the full depth rather than stopping at 75mm. The roll is a glass mineral wool product from ODE, the Turkish insulation manufacturer established in 1985, built for acoustic partition applications rather than general thermal use. Each roll measures 1200mm x 6.5m, giving 7.80m² of coverage per roll at a density of 12 kg/m³, and like the rest of the range it is supplied pre-cut into two 600mm widths for a friction-fit between standard stud centres. It carries a sound absorption coefficient of 0.8 to 1.0 and a Euroclass A1 non-combustible reaction to fire classification to BS EN 13501-1, the highest fire rating available. At 12 kg/m³ this is the lightest section in the range, which keeps a 100mm roll workable overhead in a floor void or on a tall partition run despite the thickness. The pre-cut 2 x 600mm width carries through to the thickest roll too, so installers still handle two ready-sized lengths rather than trimming down a single wide roll, and offcut waste stays low even on the shortest roll length in the range. 100mm ODE STARflex Acoustic Partition Roll HP is intended for use within internal stud partitions and floor voids, wherever reducing sound transmission between rooms, units or floors is the priority. It should be installed in line with ODE's current technical guidance and the relevant project specification. As the thickest option in the STARflex APR HP range, it suits separating walls and floor constructions where the deepest available cavity is being specified for sound control. Key Benefits of ODE STARflex Acoustic Partition Roll HP: Glass mineral wool acoustic partition roll built specifically for sound control in stud partitions and floors 45.1dB sound absorption value published by ODE for a 130mm wall with 100mm profile and 15mm plasterboard both sides, the highest figure quoted for this range Sound absorption coefficient of 0.8 to 1.0 Euroclass A1 non-combustible reaction to fire to BS EN 13501-1, the highest fire classification available Made from over 80% recycled glass content Supplied pre-cut into two 600mm widths for a friction-fit between standard stud centres 1200mm x 6.5m roll size giving 7.80m² coverage per roll at 12 kg/m³ density The thickest option in the STARflex APR HP range, suited to the deepest partition and floor voids Lightest section in the range, staying manageable to handle at full thickness Reduces on-site cutting and offcut waste compared with a single wide roll Suitable for domestic and light commercial internal partition work Engineered not to degrade, decompose or become mouldy over time, per ODE Good to Know: Top of the range: 100mm is the thickest roll in the STARflex APR HP line, for builds where the deepest available cavity is being used. The dB figure is build-specific: 45.1dB applies to the 130mm build-up quoted above. A different profile, board thickness or board layup will perform differently, so check against the project's acoustic specification. Where a build has the fullest depth to give, 100mm ODE STARflex Acoustic Partition Roll HP is built to make the most of it.