Team EAM 5400mAh 150C UUULCG ML Graph-X Formula 2S LiPo Battery

Get the Weight Down. All the Way Down. In competitive RC racing, battery selection isn't just about capacity and discharge ratings. It's also about where that weight sits in the chassis. When you're chasing better direction changes, more predictable weight transfer, and a car that's easier to drive consistently, lowering the center of gravity can be a useful part of the setup. The Team EAM 5400mAh 150C UUULCG ML Graph-X Formula LiPo takes that approach further with an exceptionally slim 16.5mm full-length case. At approximately 215-220g, it's a lightweight alternative to conventional-height full-length batteries, giving racers more freedom to manage chassis balance and ballast placement. Compared with Team EAM's 6600mAh ULCG pack, the 5400mAh is 3mm thinner and approximately 30g lighter based on the midpoint of the manufacturer's stated weight ranges. That can be an attractive trade when lowering battery mass is more valuable to your setup than carrying additional capacity. Inside, Team EAM's Multi-Layer Graph-X Formula uses stacked graphene cell construction engineered for low internal resistance and consistent voltage delivery under load. The 5400mAh capacity and manufacturer-rated 150C discharge capability make this a purpose-built option for competitive stock, spec, and modified racing. Every battery undergoes Team EAM's individual internal resistance testing and quality control before shipment. Sometimes the best way to improve the car isn't adding more. It's putting less in the right place. Features UUULCG Ultra-Low-Profile Design: Exceptionally slim 16.5mm case helps lower battery mass in compatible chassis configurations. 5400mAh Capacity: Competition-focused 2S energy capacity for stock, spec, and modified racing. Multi-Layer Graph-X Formula: Stacked graphene cell construction engineered to reduce internal resistance and support sustained voltage delivery. 150C Discharge Rating: Manufacturer-rated high-current capability for competitive racing applications. Lightweight Full-Length Configuration: Approximately 215-220g with a 139 x 47mm footprint. ROAR Legal: ROAR Approval Part Number EAM54150-2 5mm Gold-Plated Bullet Connectors: Purple copper connectors for secure electrical connections. Individually IR-Tested: Every pack undergoes Team EAM internal resistance testing and quality control before shipment. Protective Storage Box: Includes a reusable storage box. Recommended Applications 1/10 Scale Stock and Spec On-Road Racing 1/10 Scale Modified Touring Car Racing Outdoor On-Road Racing with Compatible Full-Length Battery Compartments Chassis Setups Where Low Battery Height and Ballast Placement Are Priorities Other Competitive 2S Applications Where Dimensions, Weight, and Class Rules Permit Specifications Battery Chemistry: Multi-Layer Graphene Lithium Polymer (LiPo) Capacity: 5400mAh Discharge Rating: 150C Cell Configuration: 2S Nominal Voltage: 7.4V Connector Type: 5mm Gold-Plated Bullet Dimensions: 139 x 47 x 16.5mm Weight: Approximately 215-220g ROAR Approval Part Number: EAM54150-2 Battery Care & Important Information Team EAM specifies that battery case temperature must remain below 115°F (46°C) during cycling. Exceeding this temperature may permanently damage the battery. Always use an appropriate LiPo charger and follow proper charging, storage, and handling procedures. Competition Eligibility: Team EAM describes this battery as ROAR legal. Confirm that the exact battery model appears on the current approved list and meets the requirements of your racing class before competition. Manufacturer Warranty Team EAM limits its manufacturer warranty to batteries that arrive dead on arrival (DOA). No additional manufacturer warranty is offered. This does not limit any applicable statutory consumer rights.