Challenger Power Unit for E10 / LE10 Two-Post Lifts #AB-9367-DLH

Specifications Part Number AB-9367-DLH Product Type Hydraulic Lift Power Unit Motor 3 HP, Single Phase Voltage 208-240V AC Frequency 50/60 Hz Motor Speed 2880 / 3450 RPM Pressure Relief 2900 PSI, Preset Reservoir Capacity 2.6 Gallons / Approx. 10 L Pressure Port 9/16-18 UNF Documented Application Challenger LE10; Also Sold for Compatible E10 Applications Replacement Reference 31368-21 / Earlier AB-9367 Applications Challenger 3HP Power Unit #AB-9367-DLH for E10 / LE10 Two-Post Lifts Challenger #AB-9367-DLH is a single-phase hydraulic power unit used on compatible Challenger two-post lifts. Challenger's LE10 parts breakdown specifically identifies AB-9367-DLH as the power-unit assembly for that lift, and current Challenger parts distributors also list the unit for E10 applications. The DLH configuration uses a 3 HP single-phase motor rated for 208-240V, 50/60 Hz service, with 2880/3450 RPM motor speed, a 2.6-gallon reservoir, and a preset 2900 PSI pressure-relief setting. Compatibility & Fitment Make / Brand Model Notes Challenger LE10 AB-9367-DLH listed in Challenger parts breakdown Challenger E10 Current replacement-part application; verify existing configuration AB-9367-DLH is also used on additional Challenger lift models. Always match the exact lift model, electrical requirements, and existing power-unit configuration rather than selecting by appearance alone. Product Features Complete single-phase hydraulic power unit 3 HP motor 208-240V AC electrical range 50/60 Hz operation 2880 RPM at 50 Hz / 3450 RPM at 60 Hz Preset 2900 PSI pressure relief 2.6-gallon / approximately 10-liter plastic reservoir 9/16-18 UNF hydraulic pressure port ⚠ Verify before ordering: confirm your lift model, power-unit part number, electrical service, hydraulic fitting, and pressure requirement. Do not substitute a Quick Cycle power unit or another similar-looking assembly without verifying specifications. Before Installation Disconnect and lock out electrical power before service. Confirm the circuit matches the power unit's voltage and single-phase requirement. Verify the hydraulic hose and pressure-port configuration. Inspect the reservoir and fittings for shipping damage before installation. Fill and bleed the hydraulic system according to the applicable Challenger lift manual. Do not alter the factory-set pressure relief. Frequently Asked Questions Is AB-9367-DLH listed for the Challenger LE10? Yes. Challenger's LE10 parts breakdown lists AB-9367-DLH as the single-phase power-unit assembly. What are the electrical requirements? Current specifications list 208-240V AC, single-phase, 50/60 Hz operation. What is the pressure-relief setting? The power unit is listed with a preset 2900 PSI pressure-relief setting. Does AB-9367-DLH replace the older AB-9367? Current authorized Challenger parts sources identify AB-9367-DLH as a replacement for older AB-9367 / 31368-21 applications. Confirm your specific lift configuration before making the substitution. Is the 2900 PSI relief intended to be adjusted? No. Current parts documentation describes the relief setting as preset and fixed at 2900 PSI. Questions before ordering? Call (817) 865-3707 with your Challenger lift model, serial number, and existing power-unit part number.