Ding Hang Sky Goat SG-400 750mm 4-Channel Brushless RTF RC Airplane

Ding Hang Sky Goat SG-400 750mm 4-Channel RTF RC Airplane 750mm Wingspan • 4-Channel Control • Brushless Power • EPO Foam • Battery and Charger Included The Ding Hang Sky Goat SG-400 is a compact high-wing RC trainer designed for pilots looking for an affordable introduction to full 4-channel airplane control. Its lightweight EPO foam airframe, high-wing layout, and included stabilization system are intended to provide predictable flight characteristics while still allowing control of throttle, rudder, elevator, and ailerons. Power is supplied by a 2212 1400KV brushless outrunner motor, a 20A electronic speed controller, and an included 3S 11.1V 1300mAh LiPo battery. The SG-400 uses a lightweight power system intended to provide adequate performance for general field flying, basic turns, takeoffs, landings, and introductory aerobatic maneuvers. The rudder and elevator servos are installed at the factory. Two additional 9g aileron servos are included in the box and must be installed by the user. Installation requires mounting the servos in the wing, connecting the pushrods, routing the servo wires, and centering the control surfaces before flight. The SG-400 includes a 2.4GHz 4-channel transmitter, flight battery, USB balance charger, landing gear, propeller, aileron servos, control hardware, and instruction manual. Final assembly and radio setup are required before the aircraft is ready to fly. 📏 Specifications Brand Ding Hang Model Model Name Sky Goat Model Number SG-400 Aircraft Type High-Wing Sport Trainer Completion Level RTF with Final Assembly Required Wingspan 750mm / 29.5in Length 565mm / 22.2in Flying Weight Approximately 390g / 13.8oz Airframe Material Molded EPO Foam Channels 4 Channels Primary Controls Throttle, Aileron, Elevator, and Rudder Motor 2212 1400KV Brushless Outrunner ESC 20A Brushless ESC Propeller 9 x 5 Slow-Fly Propeller Installed Servos 2 x 9g Servos for Rudder and Elevator Included Aileron Servos 2 x 9g Servos, User Installation Required Receiver Integrated 2.4GHz Receiver with Stabilization Transmitter 2.4GHz 4-Channel Transmitter Flight Battery 3S 11.1V 1300mAh LiPo Battery Battery Connector JST-Type Connector Charger USB Balance Charger Estimated Flight Time Approximately 6–8 Minutes Estimated Assembly Time 30–45 Minutes Landing Gear Fixed Wire Landing Gear with Foam Wheels Recommended Environment Large Open Field in Calm Weather Recommended Wind Less Than 5mph Skill Level Beginner to Intermediate Recommended Age 14 and Up ⚙️ Key Features Compact 750mm high-wing trainer configuration Full 4-channel control with throttle, aileron, elevator, and rudder 2212 1400KV brushless outrunner motor 20A brushless electronic speed controller Lightweight molded EPO foam construction Integrated flight stabilization system Rudder and elevator servos installed at the factory Two additional 9g aileron servos included in the box User must install, connect, center, and adjust both aileron servos Removable wing for transportation and storage Fixed wire landing gear with lightweight foam wheels Included 3S 1300mAh LiPo flight battery Included USB balance charger Approximately 6–8 minutes of flight time Best operated in calm weather and large open areas 📦 What's Included Ding Hang Sky Goat SG-400 RC Airplane 2.4GHz 4-Channel Transmitter 3S 11.1V 1300mAh LiPo Flight Battery USB Balance Charger 2 x Loose 9g Aileron Servos Aileron Pushrods and Control Horns Fixed Landing Gear Foam Wheels 9 x 5 Propeller Basic Assembly Hardware Instruction Manual 🔧 Assembly Required Install the main wing Install both aileron servos into the wing Route and connect the aileron servo wires Install the aileron control horns and pushrods Center and mechanically adjust both ailerons Install the landing gear and wheels Install the propeller Check control direction and stabilization response before flight 🔋 Required to Run 4 x AA Alkaline Batteries for the Transmitter Small Phillips Screwdriver Foam-Safe Adhesive May Be Required for Servo Installation Ding Hang Sky Goat SG-400: a compact 4-channel brushless RC trainer with included electronics, flight stabilization, and user-installed aileron servos.